Alternative anthropometric measurements for the Thai elderly: Mindex and Demiquet.

نویسندگان

  • Prasert Assantachai
  • Preyanuj Yamwong
  • Somsong Lekhakula
چکیده

This cross-sectional study examined the relationship between alternative anthropometric indices and the nutritional and metabolic status of the Thai elderly. Four rural communities, each from the 4 main regions of Thailand were surveyed. A total of 2,324 subjects, 60 years old and over were included in the study. Mindex and Demiquet had a very strong relationship to body mass index with the r values of 0.93 and 0.88, respectively. Fat weight had the highest correlation with body mass index in older women, r = 0.94 (P< 0.001) and with Mindex, r = 0.93 (P< 0.001). In regard to anthropometric measurements, the mid-arm circumference had the strongest relationship to all three Quetelet indices, r = 0.76-0.87 (P< 0.001), while subscapular skinfold thickness performed best among skinfold measurements, r = 0.69-0.74 (P< 0.001). BMI achieved a significantly higher degree of correlation with triceps and supra-iliac skinfold thickness, mid-arm circumference and fat weight than Demiquet (P< 0.001 for all variables). The lymphocyte count was the only laboratory test that related rather well to all three Quetelet indices. All three Quetelet indices had nearly the same pattern of relationship to various nutritional parameters. The cut-off points of Mindex denoting under-nutrition, overweight and obesity I in women were 55.95, 69.55 and 75.60 kilogram/metre, respectively. At the same time, the cut-off points of Demiquet denoting under-nutrition, overweight and obesity I in men were 75.60, 93.98 and 102.16 kilogram/metre2, respectively. All this information supports the benefit of using Mindex and Demiquet as alternatives to body mass index for nutritional assessment in older Asian people, especially for the malnourished ones.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

مقایسه اندازه‌گیری‌های به دست آمده ‌از آنالیز مک نامارا با معادل‌های پیشنهادی روی بافت نرم

Background and Aims: Cephalometric measurements cannot be performed for screening purposes, therefore orthodontists usually have to use either photographic or anthropometric measurements in such occasions. Finding a valid and reliable alternative could be of great value. The purpose of this study was to evaluate the correlation between McNamara's cephalometric unit difference and a proposed sof...

متن کامل

Effects of Ramadan fasting on neonatal anthropometric measurements in the third trimester of pregnancy

Introduction: Ramadan Fasting is prescribed by Holy Quran for every able-bodied, adult Muslim and is considered an essential practice for all Muslims including pregnant women. The aim of this study was to determine the effect of Ramadan fasting on neonatal anthropometric measurements during the third trimester of pregnancy. Method: This is a cross-sectional study, carried out on 300 delivering ...

متن کامل

ارتباط برخی شاخص‎های آنتروپومتریک با ثبات وضعیتی و دامنه حرکتی مفاصل مچ پا و ران در سالمندان

Background and purpose: There are conflicting results in the literature about the relationship between anthropometric factors and postural stability of people. No study has investigated the role of anthropometric changes in the variation of balance recovery mechanisms. The present study aimed to examine the relationship between anthropometric factors and postural stability and the association b...

متن کامل

Massage therapy in the relief of knee osteoarthritis symptoms in the elderly: a systematic review

Aims: Research has shown that most of the elderly suffer from knee osteoarthritis. Massage therapy is one of the non-pharmacological methods that according to studies can be used to relieve the symptoms caused by knee osteoarthritis in the elderly. Therefore, the present study was conducted with the aim of reaching a comprehensive view on massage therapy in relieving the symptoms of knee osteoa...

متن کامل

Effectiveness of alumina nanofluid on slotting end milling performance of SKD 11 tool steel

SKD 11 tool steel is among the most popular metals in mold industries for making different kinds of cold work molds and dies with high accuracy and long service life. The demand for higher quality, lower manufacturing costs, particularly the environmentally friendly characteristics, have provided the stimuli for manufacturers and researchers to find alternative solutions. An excellent media is ...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:
  • Asia Pacific journal of clinical nutrition

دوره 15 4  شماره 

صفحات  -

تاریخ انتشار 2006