Loopback BiST for RF Front-Ends in Digital Transceivers
نویسنده
چکیده
This paper addresses a built-in self-test (BiST) for ICs digital transceivers. The focus is on testing the RF frontend while taking advantage of the on-chip DSP resources and DA-, AD converters. The loopback architecture is used to prevent the sensitive RF blocks from extra noise and external disturbances. The test aims at spot defects typical of RF CMOS ICs, where those faults are deemed the main yield limiter in mass production. The fault model is discussed at three levels of design abstraction: layout, circuit and functional block. The BiST model is verified at the circuit and functional level. As a demonstrator a GSM transceiver model with loopback BiST is presented that provides a promising result.
منابع مشابه
RF On-chip Test by Reconfiguration Technique
The paper addresses on-chip test for IC RF transceivers. The baseband DSP available on chip serves as a tester while the RF front-end is reconfigured for test. The basic test setup is a loopback, enabled by a test attenuator and in some cases by an offset mixer, too. Different variants of this setup adopt the bypassing technique to boost testability. The existing limitations and tradeoffs in te...
متن کاملMulti-Band Multi-Standard CMOS Receiver Front-Ends for 4G Mobile Applications
The development of the transistor and its continuous down-scaling has allowed during the last decades the appearance of cheap wireless communication systems targeting consumer products. The complexity of these systems has increased dramatically during the last years, mainly fueled by both the Moore law and improvements in communication theory. Originally, the radio transceivers were composed of...
متن کاملEvaluating the Digital Fault Coverage for a Mixed-Signal Built-In Self-Test by
This thesis focuses on a digital Built-in Self-Test (BIST) approach to perform specification oriented testing of the analog portion of a mixed-signal system. The BIST utilizes a direct digital synthesizer (DDS) based test pattern generator (TPG) and a multiplieraccumulator (MAC) based output response analyzer (ORA) to stimulate and analyze the analog devices under test, respectively. This appro...
متن کاملBuilt-In Measurements in Low-Cost Digital-RF Transceivers
Digital RF solutions have been shown to be advantageous in various design aspects, such as accurate modeling, design reuse, and scaling when migrating to the next CMOS process node. Consequently, the majority of new low-cost and feature cell phones are now based on this approach. However, another equally important aspect of this approach to wireless transceiver SoC design, which is instrumental...
متن کاملHighly Linear Mixer for On-Chip RF Test in 130nm CMOS
The complexity of wireless communication integrated circuits is increasing day by day due to the trend of multifunction and multistandard support. This has not only increased the production cost of these RFICs but the testing cost is also increased significantly, as much advanced test equipments and instruments are needed to carry out the sophisticated performance tests. To avoid this higher co...
متن کامل