Calcium Phosphate Bone Cement Preparation using Mechano- Chemical Process

ACP (amorphous calcium phosphate) and DCPD (dicalcium phosphate dihydrate, or Brushite) powders were high energy dry ball milled at a 1:1 ratio for 1, 2, 3, 4, 10, or 24 hours to produce a variety of powders for use as calcium phosphate cements (CPC). A 1:1 blend of powders not subjected to milling was used as baseline material (control). Physicochemical and mechanical characterization was performed on the powder or cement at each milling time point and compared to control. The following changes were noted after 24 hours of milling: the crystallinity was reduced to a fully amorphous phase, the tap density increased by 89%, the specific surface area decreased by a factor of 7, and the total porosity of hardened cement decreased by 50%. Additionally, the compressive strength of hardened CPC increased from 2.6 MPa to a peak of 50 MPa after 10-h milling. The rate of paste hardening increased throughout the 24-h period. Full conversion of each milled material produced a similar composition low-crystalline calcium deficiency apatite with Ca/P atomic ratio of 1.45 and specific surface area around 195 m 2 /g. The specific structure of these CPC, with high surface area and reactivity of nano-crystals, is ideal for in vivo remodeling of new bone and controlled release of protein and growth factors.