Formation and Dissolution of γ’ Precipitates in IN792 Superalloy at Elevated Temperatures
نویسندگان
چکیده
Precipitation of γ’ phase in nickel-base superalloy IN792-5A was studied using in-situ Small Angle Neutron Scattering (SANS). It was found that additional precipitates are formed after reheating above 600 ̋C when the material is previously fast cooled (100 K/min) from 900 ̋C. The size distribution and volume fraction of the additional γ’ precipitates as well as of the already present medium-size precipitates in dependence on temperature were evaluated. The small precipitates can influence mechanical properties of the alloy, which exhibits an anomaly in the temperature dependence of the yield stress. Volume fraction of all precipitate populations above 900 ̋C was estimated as well.
منابع مشابه
Flow Stress Modeling in a γ-γ/ Cobalt Base Superalloy by Using the Hyperbolic Sine Equation and ANN Method
The new class of wrought γ-γ/ Co-base superalloys, which are based on Co-Al-W system, was developed by conventional hot working routes with a high volume fraction of γ/ precipitates and good mechanical properties. The aim of the present study was to predict the flow stress and hot deformation modeling of a novel γ-γ/ Co-base superalloy. The hot compression test...
متن کاملThe Effect of High Temperature Exposure on Dendritic Segregation in a Conventionally Cast Ni Based Superalloy
Dendritic segregation in conventionally cast, commercially heat treated and exposed MarM002 turbine blades has been investigated using scanning electron microscopy (SEM) and energy dispersive X-ray analysis (EDS). During casting Cr, Co and W segregate to the dendrites and Hf, Ti and Ta segregate to the eutectics. As a result of the dissolution of γ' precipitates in the dendrites and coarsening ...
متن کاملمحاسبه کرنش الاستیک هم سیمایی برای مورفولوژی های مختلف رسوبات ’γ در یک سوپر آلیاژ پایه نیکل
Coherency elastic strain between γ and is one of the effective factors which affect the morphology, spatial re-arrangement and coarsening kinetics of precipitates in nickel-base superalloys. In this investigation, using X-ray diffraction (XRD) technique, the - constrained and unconstrained lattice misfits were calculated for different morphologies of the precipitates in Inconel 738L...
متن کاملAnalysis of Cracks in the Pulsed Nd:YAG Laser Welded Joint of Nickel-Based Superalloy
The weldability of GTD-111 nickel-based superalloy by pulsed Nd:YAG laser welding with an average power of 250 W was studied, and the microstructural evolution and cracking characteristics were also investigated. The solidification cracking of the fusion zone (FZ) and the intergranular liquation cracking in the heat affected zone (HAZ) were observed in the joint. Solidification cracking was cau...
متن کاملInfluence of Solidification Conditions on TCP Phase Formation, Casting Porosity and High Temperature Mechanical Properties in a Re-Containing Nickel-Base Superalloy with Columnar Grain Structure
A coarse and a fine dendrite structure were produced using the newly developed DS-superalloy ExAl7 ( IN792 with 2-3 wt.-% Re) by changing the conditions of directional solidification. The two microstructures differed in their primary dendrite arm spacing by a factor of 1.6. During aging, very fine TCP phase precipitates (length approximately 20 m, volume fraction ~ 1 %) were precipitated in the...
متن کامل