Fixed and Incremental Levels of Microwave Power Application on Drying Grapes under Vacuum
نویسندگان
چکیده
Microwave vacuum drying has been investigated as promising potential for high-quality dried fruits. In this study, a batch microwave vacuum dryer was used to understand the effect of levels of microwave power on the drying characteristics and moisture content of grapes. Thompson seedless grapes were treated 1st for 30, 60, and 90 min at fixed levels of 500, 750, 1000, 1250, and 1500 W at a reduced pressure of 2.7 kPa and then treated by 3 staged microwave power levels: a higher level of power during the initial stages of dehydration and 2 subsequently lower levels of power applied as the moisture content decreased. A typical temperature profile was found during the drying process, linearly increasing at the start of drying, followed by a nearly constant value during the drying period while water was evaporating. The total specific energy estimated by the energy balance model was 0.97 to 1.01 W-h/g of fresh grapes and agreed well with the experimental specific energy of 0.85 to 0.90 W-h/g for the fixed power tests. The multiple regression results showed that the specific energy was the most influential parameter on the final moisture content of grapes both in fixed and incremental power levels. Further research is needed to further improve the process with high efficiency and good product quality using product temperature as a control measure.
منابع مشابه
Pulsed Vacuum Osmotic Dehydration of Garlic Bulbs Followed by Microwave Drying
ABSTRACT: The combination of pulsed vacuum osmotic dehydration and microwave drying of garlic bulbs were examined. The response surface methodology (RSM) was used to determine the effect of NaCl concentration (8%-20%), osmotic solution temperature (25-65°C), operation pressure (240-830 mbar), immersion time (20-300 min) and microwave power level (100-600 W) on water loss (WL), solids gain (SG),...
متن کاملImproving grape quality using microwave vacuum drying associated with temperature control.
Microwave (MW) vacuum dehydration using temperature to control the level of MW power demonstrated potential in improving the performance of the process. Product surface temperature measured by an infrared temperature sensor was used to control MW power at any level between 0 and 3 kW. Multiple linear regression analysis indicated an r2 = 0.942 for prediction of final moisture content and r2 = 0...
متن کاملMicrowave Assisted Vacuum Drying and Endpoint Determination Using Mass Spectrometry
Microwave drying technology has the potential for large production time and energy cost savings versus traditional vacuum drying methods for active pharmaceutical ingredient (API) applications. One of the most critical parameters in the drying process is the determination of the end point, usually at a specified moisture content. On-line mass spectrometry (MS) was used as a tool to monitor micr...
متن کاملEvaluation of Energy Consumption of Potato Slices Drying Using Vacuum-Infrared Method
Objective: The main objective pursued in this paper is to investigate the energy consumption for drying of potato slices using vacuum-infrared drying method. Methods: Drying of potato slices with the thicknesses of 1, 2 and 3 mm were conducted at vacuum levels of zero (without vacuum), 20, 80 and 140 mm [Hg], infrared radiation at power levels of 100, 150 and 200 W in the three repetition. Resu...
متن کاملEvaluation of Energy Consumption of Potato Slices Drying Using Vacuum-Infrared Method
Objective: The main objective pursued in this paper is to investigate the energy consumption for drying of potato slices using vacuum-infrared drying method. Methods: Drying of potato slices with the thicknesses of 1, 2 and 3 mm were conducted at vacuum levels of zero (without vacuum), 20, 80 and 140 mm [Hg], infrared radiation at power levels of 100, 150 and 200 W in the three repetition. Resu...
متن کامل