Automated determination of fatty acid methyl ester and cis/trans methyl ester composition of fats and oils.

The determination of the fatty acid composition (as methyl esters, FAMEs) of fats and oils and their cis/trans (CTME) distribution requires a simple, but manual and time-consuming sample preparation. The so-called BF3 method is often the preferred procedure. Because FAME/CTME analyses are encountered very frequently in the food industry, an automated, robot-based alternative is proposed which uses the sodium methylate procedure. After sample weighing and the (manual) addition of heptane (2 min), a XYZ robotic autosampler is used for all remaining work, which includes reagent addition, agitation, sample settling and the final injection into the gas chromatograph (10 min). The performance of the sodium methylate and BF3 methods are compared by analysing some 30 oil and fat samples. The novel procedure is much faster (less than 15 min versus ca. 1 h) and manual sample handling is drastically decreased. The experimental results obtained with the two methods frequently are the same, while small differences can be explained by (known) differences of the two methods in the conversion of minor oil/fat constituents, such as free fatty acids, wax esters and sterol esters. In case of FAME analyses, a hot injection is to be preferred over a cold injection. The RSDs of the peak areas were 1.5% for the major fatty acids to 11% for peaks that were just above the noise level. The detection limit were approximately 0.03%.