Feed Water Line Cracking in Pressurized Water Reactor Plants
نویسنده
چکیده
منابع مشابه
NUREG/CR-6726, Aging Management and Performance of Stainless Steel Bellows in Nuclear Power Plants
In commercial nuclear power plants, many containments use stainless steel bellows at piping penetrations, in dry well-to-wetwell vent lines, or as a part of the fuel transfer tube. Bellows are an integral part of the primary contain ment pressure boundary in nuclear power plants. These bellows allow for thermal expansion and contraction of the pipe, vent line, or fuel transfer tube, and accommo...
متن کاملAdvanced Construction Methods for New Nuclear Power Plants - NTR2009 Supplement
Relative to coal fired and natural gas fired power plants, nuclear power plants are more expensive to build but less expensive to run. This annex describes advanced construction methods to reduce nuclear power's construction costs, mainly by shortening the time needed to build a plant. Each of the methods described below has been used in one or more of the projects listed in Table IV-1. None is...
متن کاملAssessment of NDE technologies for detection and characterization of stress corrosion cracking in LWRs
Stress corrosion cracking (SCC) in light water reactors (LWRs) has been a persistent form of degradation in the nuclear industry. Examples of SCC can be found for a range of materials in boiling and pressurized water reactor environments, including carbon steels, stainless steels, and nickel-base alloys. The evolution of SCC is often characterized by a long initiation stage followed by a phase ...
متن کاملNeural Network Controller for the Pressurized Water Reactor Power Control
Although there have been some severe nuclear accidents such as Three Mile Island (USA), Chernobyl (Ukraine) and Fukushima (Japan), nuclear fission energy is still a source of clean energy that can substitute fossil fuels in a centralized way and in a great amount with commercial availability and economic competitiveness. Since the pressurized water reactor (PWR) is the most widely used nuclear ...
متن کاملUse of Secondary Ions Mass Spectrometry (SIMS) for Cladding Materials Post- Irradiation Examination (PIE)
Zirconium-based alloys are widely used in the field of nuclear industry as cladding for nuclear fuel in power plants. In a pressurized water reactor (PWR), boric acid is added in the coolant for reactivity control. Lithium hydroxide is added to render the coolant slightly alkaline, which helps to inhibit corrosion product deposition on the fuel cladding and reduces the corrosion rate of structu...
متن کامل