A new wide-band amplifier technique
نویسنده
چکیده
This paper describes a technique for the design oftwo-signal four-quadrant multipliers, Iiiear on both inputs and use-ful from dc to an upper frequency very close to the -f~of the transis-tors comprising the circuit. The precision of the product is shown tobe limited primarily by the matchmg of the transistors, particularlywith reference to emitter-junction areas. Expressions are derivedfor the nonlinearities due to various causes.
منابع مشابه
Self-Equalized Distributed Amplifier for Wide Band Optical Transceivers
A novel technique for a self-equalized distributed amplifier is presented by showing the analogy between transversal filters and distributed amplifier topologies. The appropriate delay and gain coefficients of amplifier circuit are obtained by a Fourier expansion of the raised cosine spectrum in the frequency range of 0-40GHz.
متن کاملA 28-36 GHz Optimized CMOS Distributed Doherty Power Amplifier with A New Wideband Power Divider Structure
Background and Objectives: In this paper, a new design strategy was proposed in order to enhance bandwidth and efficiency of power amplifier. Methods: To realize the introduced design strategy, a power amplifier was designed using TSMC CMOS 0.18um technology for operating in the Ka band, i.e. the frequency range of 26.5-40GHz. To design the power amplifier, first a power divider (PD) with a ver...
متن کاملNonlinear Analysis of a Power Amplifier inc C Band and Load Pull Technique Calculation USING VOLTERRA SERIES
In recent years, nonlinear circuit analysis techniques have been extensively investigated. One of the most important reasons is the application development of solid-state devices at microwave frequencies. Different methods have been used to analysis large signal behavior of these devices. In this paper load-pull curves (one of design requirement) are obtained using Volterra series. The main adv...
متن کاملA W-band Simultaneously Matched Power and Noise Low Noise Amplifier Using CMOS 0.13µm
A complete procedure for the design of W-band low noise amplifier in MMIC technology is presented. The design is based on a simultaneously power and noise matched technique. For implementing the method, scalable bilateral transistor model parameters should be first extracted. The model is also used for transmission line utilized in the amplifier circuit. In the presented method, input/output ma...
متن کاملAnalyzing the Effect Adding an Active Feedback Network with an Inductive behavior to a Common-Gate Topology as a Transimpedance Amplifier for Low-Power and Wide-Band Communication Applications
Common Gate (CG) topologies are commonly used as the first stage in Transimpedance Amplifiers (TIA), due to their low input resistance. But, this structure is not solely used as a TIA and comes with other topologies such as differential amplifiers or negative resistances and capacitances. This paper deals with analyzing the effect of adding an active feedback network to a common gate topology...
متن کاملDesign of an S-band Ultra-low-noise Amplifier with Frequency Band Switching Capability
In this paper, an ultra-low-noise amplifier with frequency band switching capability is designed, simulated and fabricated. The two frequency ranges of this amplifier consist of the 2.4 to 2.5 GHz and 3.1 GHz to 3.15 GHz frequency bands. The designed amplifier has a noise figure of less than 1dB, a minimum gain of 23 dB and a VSWR of less than 2 in the whole frequency band. The design process s...
متن کامل