Effects of SDS on the sol–gel transition of methylcellulose in water
نویسندگان
چکیده
The effects of an anionic surfactant, sodium dodecyl sulphate (SDS), on the optical transmittance, thermal, and rheological properties of methylcellulose (MC) aqueous solutions have been studied. The particular interest of this work was focused on the effects of SDS on the sol–gel transition of MC. Basically, two effects of SDS have been identified, which are the salt-out and salt-in effects at low (%6 mM) and high (O6 mM) concentrations of SDS, respectively. The salt-out effect of SDS is to bring the gelation of MC to lower temperatures, whereas the salt-in effect of SDS is to make the gelation of MC to occur at higher temperatures. In addition, SDS is also able to alter the pattern of gelation. Especially, when the concentration of SDS is greater than 8 mM, SDS not only delays the overall gelation of MC but also changes the pattern of MC gelation from a single mode to a bimodal one. q 2005 Elsevier Ltd. All rights reserved.
منابع مشابه
Preparation of SLN-containing Thermoresponsive In-situ Forming Gel as a Controlled Nanoparticle Delivery System and Investigating its Rheological, Thermal and Erosion Behavior
AbstractVarious nanoparticles have been investigated as novel drug delivery systems, including solid lipid nanoparticles (SLNs). Due to their rapid clearance from systemic circulation, nanoparticles do not provide sustained action in most cases. Different strategies have been employed to overcome this problem. In this direction, the present study introduces erodible in-situ forming gel systems ...
متن کاملPreparation of SLN-containing Thermoresponsive In-situ Forming Gel as a Controlled Nanoparticle Delivery System and Investigating its Rheological, Thermal and Erosion Behavior
AbstractVarious nanoparticles have been investigated as novel drug delivery systems, including solid lipid nanoparticles (SLNs). Due to their rapid clearance from systemic circulation, nanoparticles do not provide sustained action in most cases. Different strategies have been employed to overcome this problem. In this direction, the present study introduces erodible in-situ forming gel systems ...
متن کاملEffects of MWCNTs Dispersion on the Microstructure of Sol-Gel Derived Hydroxyapatite
Stable homogeneous dispersions of carbon nanotubes (CNTs) were prepared using ethanol as dispersing agent. Then, using sol-gel method, dispersion in the hydroxyapatite matrix and its effects on the microstructure were investigated. The phase composition, chemical structure and morphological and size analyses were performed using XRD, FT-IR, SEM, TEM/SAED/EDX and Raman spectroscopy. The influenc...
متن کاملSynthesis and characterization of Alumina (Al2O3) nanoparticles prepared by simple sol-gel method
Alumina is one of the most widely used ceramic materials as catalysts, catalyst supports and absorbents, and also wear resistant coating. This study focused on fabricating and characterizing of alumina ceramic nanoparticles fabricated using new and simple sol-gel method. Aluminium oxide (Al2O3) nanoparticles were synthesized by iron (III) nitrate 9-hydrate as precursor. Physicochemical properti...
متن کاملA comparative study between transition-metal-substituted Keggin-type tungstosilicates supported on anatase leaf as catalyst for synthesis of symmetrical disulfides
Transition-metal-substituted (TMS) polyoxometalates of the general formula [SiW9M3O39], (where M = first row transition metal), has been synthesized and supported on anatase by sol–gel method under oil-bath condition. The tetrabutylammonium (TBA) salts of the Keggin-type polyoxotungstates [SiW9M3O39], (M = VII, CrII, MnII, FeII CoII and NiII), proved to be green, reusable, and ...
متن کامل