A high rate flow-focusing foam generator
نویسندگان
چکیده
We use a rigid axisymetric microfluidic flow focusing device to produce monodisperse bubbles, dispersed in a surfactant solution. The gas volume fraction of the dispersion collected out of this device can be as large as 90%, demonstrating that foam with solid-like viscoelastic properties can be produced in this way. The polydispersity of the bubbles is so low that we observe crystallization of our foam. We measure the diameter of the bubbles and compare these data to recent theoretical predictions. The good control over bubble size and foam gas volume fraction shows that our device is a flexible and promising tool to produce calibrated foam at a high flow rate.
منابع مشابه
Dry microfoams: Formation and flow in a confined channel
We present an experimental investigation of the agglomeration of microbubbles into a 2D microfoam and its flow in a rectangular microchannel. Using a flow-focusing method, we produce the foam in situ on a microfluidic chip for a large range of liquid fractions, down to a few percent in liquid. We can monitor the transition from separated bubbles to the desired microfoam, in which bubbles are cl...
متن کاملMATHEMATICAL MODELLING OF THE EFFECT OF FOAM DEGRADATION ON MOULD FILLING IN THE GREY IRON EPC PROCESS
In this investigation a new model was developed to calculate gas pressure at the melt/foam interface (Gap) resulting from foam degradation during mould filling in the Lost Foam Casting (LFC) process. Different aspects of the process, such as foam degradation, gas elimination, transient mass, heat transfer, and permeability of the refractory coating were incorporated into this model. A Computati...
متن کاملFoam mechanics at the bubble scale.
By focusing on entire bubbles rather than films or vertices, a simple model is proposed for the deformation and flow of foam in which dimensionality, polydispersity, and liquid content can easily be varied. Simulation results are presented for the linear elastic properties as a function of bubble volume fraction, showing a melting transition where the static shear modulus vanishes and the relax...
متن کاملEXPERIMENT AND APPLICATION OF AN ANNULAR FOAM BREAKER FOR FOAM DRILLING FLUID (RESEARCH NOTE)
The annular foam breaker is one which uses the vacuum and shear force generated by the Coanda effect to break foam. Its effectiveness in destroying drilling foam has been test in wellbore flow simulation loop experimental stand. Experimental results showed that the operating pressure of the annular foam breaker should be larger than 0.6MPa and the stabilizers concentration of the foam drilling ...
متن کاملFLOW BEHAVIOR OF MOLTEN METAL IN ALUMINUM LFC PROCESS
The effects of gating system and pattern geometry on the metal flow in the lost foam casting (LFC) process have been investigated using glass covered mold and video recording system. Unlike convectional casting process, the type of the gating system showed little effect on fillability in lost foam, but pattern thickness had large effect on mold filling. The mold filling behavior seems to be con...
متن کامل