Microwave transmission through a metal capped array of holes in a metal sheet.
نویسندگان
چکیده
The microwave response of a square array of "metal capped" holes in a metal sheet is explored both experimentally and numerically. Above each circular aperture are concentrically placed metallic discs, separated by a fraction of the wavelength, with discs having radii larger than the apertures. The volume bound by the overlap supports a family of resonances that mediate transmission with the fundamental resonant mode being a factor of ~2.3 lower in frequency than the bare aperture resonance.
منابع مشابه
FABRICATION AND MODELING OF PASSIVE COMPONENTS FOR InP-BASED MMICs
Passive components for use in planar Monolithic Microwave Integrated Circuits (MMICs) based on High Electron Mobility Transistors (HEMTs) on indium phosphide substrates are presented. Design, fabrication, and modeling issues of capacitors, resistors, inductors, transmission lines, via holes, and air bridges have been addressed. Sputtered thin films have been utilized to make metal-insulator-met...
متن کاملExtraordinary light transmission through opaque thin metal film with subwavelength holes blocked by metal disks.
We observed that when subwavelength-sized holes in an optically opaque metal film are completely covered by opaque metal disks larger than the holes, the light transmission through the holes is not reduced, but rather enhanced. Particularly we report (i) the observation of light transmission through the holes blocked by the metal disks up to 70% larger than the unblocked holes; (ii) the observa...
متن کاملTransmission through and Wave Guidance on Metal Plates Perforated by Periodic Arrays of Through-holes of Subwavelength Coaxial Cross- Section
Perfect electrically conducting (PEC) plates perforated by doubly periodic arrays of through-holes of subwavelength coaxial cross-section permit enhanced transmission of plane waves and support surface wave guidance. The transmission enhancement is attributed to coupling of free-space fields to TEM and TE11 modal fields in holes and occurs via two distinct mechanisms. The first couples incident...
متن کاملMethod for the Measurement of Scattering Coefficients Using a Metal-Plate Reflector in the Microwave Region
A new method for measuring the scattering coefficient using a metal-plate reflector was developed in order to provide a non-destructive way for the assessment of microwave materials in free space. By displacing the position of the metal-plate reflector on the specimen to be tested, the incident wave and the scattered wave from the measured area were determined without the influence of extraneou...
متن کاملWaveguide arrays as plasmonic metamaterials: transmission below cutoff.
Since the work of Ebbesen et al. [Nature (London) 391, 667 (1998)], there has been immense interest in the optical properties of subwavelength holes in metal layers. While the enhanced transmission observed is generally associated with surface plasmon polaritons (SPPs), theoretical predictions suggest a similar response with perfectly conducting materials. However, Pendry et al. [Science 305, 8...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
- Optics express
دوره 18 23 شماره
صفحات -
تاریخ انتشار 2010