Structural Ceramic Components by 3d Printing
نویسندگان
چکیده
The Three Dimensional Printing (3DP) Process hasbe~nadapted for processing of fine ceramic powders to •• prepare structllraLceramic components. Our preliminary study was designed to reveal those aspects ofthe.3DPprocesswhichmust be modified for use with fine ceramic powders. The basic elements of the modified process are to spread submicron alumina powder and printJatex binder. Several methods were used to spread thin layers of submicron powders. Gre.enparts are isostaticaUypressed followed by thermal decomposition prior to sintering to remove the polymer. The fired alumina components are greater than 99.2% dense and have·average flexural strength of324 MPa. This is lower than the best conventionally prepared alumina, but we believe that the strength results will improve as we learn more about the relationship between strength limiting flaws and the 3DP build process.
منابع مشابه
Porous Ceramic Filters through 3d Printing
This paper describes current and on-going work in adapting Z-Corp 3D printers to operate with low-cost ceramic materials. The components produced with these clay-based ceramic powders can be fired to produce strong, complex and lightweight ceramic parts. The final material properties, including the porosity of the parts, can be controlled through the part design and, potentially, through additi...
متن کاملCeramic-Based 4D Components: Additive Manufacturing (AM) of Ceramic-Based Functionally Graded Materials (FGM) by Thermoplastic 3D Printing (T3DP)
In our study, we investigated the additive manufacturing (AM) of ceramic-based functionally graded materials (FGM) by the direct AM technology thermoplastic 3D printing (T3DP). Zirconia components with varying microstructures were additively manufactured by using thermoplastic suspensions with different contents of pore-forming agents (PFA), which were co-sintered defect-free. Different materia...
متن کاملProperties of Partially Stabilized Zirconia Components Fabricated by the Ceramic On-demand Extrusion Process
The Ceramic On-Demand Extrusion (CODE) process is a novel additive manufacturing process for fabricating dense ceramic components from aqueous pastes of high solids loading. In this study, 3 mol% Y2O3 stabilized tetragonal zirconia polycrystal (3Y-TZP) parts were fabricated using the CODE process. The parts were then dried in a humidity controlled environmental chamber and sintered under atmosp...
متن کامل3D Printed Ceramics for Tableware, Artists/Designers and Specialist Applications
The Centre for Fine Print Research at the University of the West of England has over five years experience in the 3D printing of ceramic materials. The first project undertaken was to investigate the use of 3D technologies for artists and resulted in the development of a patented ceramic body suitable for use in Z Corporation 3D printers. After bisque firing this material can be further process...
متن کامل3d-printing of Energy Devices Using Particle-based Inks
Introduction and Summary Over the past year, ISEN funding has been utilized to make significant research progress towards the fabrication of a fully 3D-printed iron/solid oxide fuel cell (Metallic/multi-ceramic) batterygenerator system (Figure 1). Monies have gone towards the partial funding of one grad student/postdoc, Adam Jakus, in Ramille Shah’s Tissue Engineering and Additive Manufacturing...
متن کامل