Microleakage of a self-adhesive class V composite on primary and permanent dentitions.
نویسندگان
چکیده
AIM This study aimed to evaluate the microleakage of Class V restorations filled with a 7th-generation self-adhesive composite. MATERIALS AND METHODS In 40 permanent premolars and 80 primary canines, 160 Class V cavities were prepared, which were filled with four restorative materials (n of each material=20 permanent and 20 primary restorations): control: nonbonded composite (Heliomolar), GI: glass ionomer (Fuji IX GP), BC: bonded Heliomolar, SC: self-adhesive composite (Embrace WetBond). Dye penetration was scored 0 to 4 at 160 coronal and 160 gingival margins under 40× magnification by two examiners. The data were analyzed with Mann-Whitney U test (α=0.01). RESULTS The mean microleakages of the materials (in the order of 'control, GI, BC, SC') at each margin-dentition (n=20 margins) were: coronal-permanent (3.25±0.72, 2.75±0.72, 0.35±0.59, 2.7±0.73), coronal-primary (3.3±0.66, 2.85±0.88, 0.55±0.76, 2.65±1.14), gingival-permanent (3.35±0.67, 0.85±0.67, 2.95±0.83, 1.55±1.23), and gingival-primary (3.25±0.72, 0.85±0.59, 2.85±0.89, 2.85±0.93). Compared with the control microleakage at each margin-dentition (each group's n=20 margins), BC microleakage was significantly lesser at coronal margins only (p=0.000), GI microleakage was lower at gingival margins only (p=0.000), and SC microleakage was smaller at gingival margins of permanent teeth only (p=0.000). After combining coronal/gingival margins, only SC microleakage in primary dentition (n=40 margins) was not significantly lesser than the control in primary teeth (p=0.018); and microleakage of all other material-dentitions were lesser than corresponding control-dentitions (p=0.000). Permanent and primary teeth had similar results for all material-margins (p>0.5) except for SC at gingival margins (p=0.001). CONCLUSION SC should be used only at gingival margins of permanent teeth. CLINICAL SIGNIFICANCE Application of self-adhesive composite should be limited to gingival margins of permanent teeth.
منابع مشابه
Microleakage comparison of three types of adhesive systems versus GIC-based adhesive in class V composite restorations
Background and aims: New dentin bonding agents and techniques have been developed to reduce microleakage and create higher bond strength. This in-vitro study compared the microleakage of three resin-based adhesives versus a GIC-based adhesive on class V composite restorations. Materials and Methods: Class V cavities were prepared on the buccal surfaces of 72 sound premolars, randomly assigned ...
متن کاملComparative evaluation of microleakage of composite restorations using fifth and seventh generations of adhesive systems
Introduction: Simultaneous etching of enamel and dentin using the novel generation of adhesive systems with contracted operational steps, has shown a good clinical efficacy. The aim of this study was to evaluate the microleakage of composite restorations using the V and VII generations of adhesive systems on primary teeth. Methods: This study was performed on 45 human intact extracted primar...
متن کاملEvaluation of Diode laser (940 nm) irradiation effect on microleakage in class V composite restoration before and after adhesive application
Introduction: Nowadays, the main focus of dental studies is on adhesive dental materials; since clinical long-term success of bonded restorations depended more on marginal microleakage minimization. So, the aim of this study was Evaluation of Diode laser irradiation effect on microleakage in class V composite restoration before and after adhesive application. Materials and methods: In this in v...
متن کاملIn Vitro Microleakage of Class V Composite Restorations in Use of Three Adhesive Systems
Background and Aim: Microleakage is a drawback of composite restorations and it is more noticeable in dentinal walls. Despite advances in dentin bonding agents, no adhesive can completely eliminate microleakage and provide a hermetic seal. This study aimed to compare microleakage of three resin bonding agents namely a universal adhesive, two-step self-etch system and two-step total-etch system....
متن کاملبررسی مقایسهای خارج دهانی ریزنشت چهار نوع سیستم چسبنده عاجی در ترمیمهای کامپوزیتی دندانهای شیری و دائمی
Background and Aim: Although the use of adhesive systems can be effective in decreasing microleakge, it is still a major problem in composite resin restorations. The aim of the present study was to evaluate the marginal sealing ability of resin composite restorations using four dentin bonding systems in both primary and permanent teeth. Materials and Methods: In this experimental study, one hun...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید
ثبت ناماگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید
ورودعنوان ژورنال:
- The journal of contemporary dental practice
دوره 14 3 شماره
صفحات -
تاریخ انتشار 2013