Active chatter control for high-speed milling using μ-synthesis
نویسندگان
چکیده
In todays manufacturing industry, high-speed milling plays an important role. The main benefits of high-speed milling over conventional milling are the high material removal rates with relatively low cutting forces. The efficiency of high-speed milling is limited by the occurrence of regenerative chatter. Chatter is an undesired instability phenomenon, causing excessive tool vibrations, reduced product quality and rapid tool wear.
منابع مشابه
Chatter control in the high-speed milling process using μ-synthesis
Chatter is an instability phenomenon in machining processes which limits productivity and results in inferior workpiece quality, noise and rapid tool wear. The increasing demand for productivity in the manufacturing community motivates the development of an active control strategy to shape the chatter stability boundary of manufacturing processes. In this work a control methodology for the high...
متن کاملControl of a High Speed Machining Spindle via μ-Synthesis
Due to high surface speed and active control capabilities, active magnetic bearings hold great promise for high speed machining spindles. Herein, the control problem posed by this application is examined and the development of an advanced prototype is reviewed. A μ synthesis framework is proposed for this problem and it is shown that the minimization of the susceptibility to machining chatter m...
متن کاملStability Lobe Diagram for High Speed Machining Processes:Comparison of Experimental and Analytical Methods – A Review
Chatter is a complicated problem faced by machine tool operators. Chatter is a self-excited vibration that can occur during machining operations. This is an undesirable phenomenon which limits the productivity of the machine. A lot of techniques have been developed to control the chatter. Stability lobe diagram is an effective tool which helps the operator to select specific spindle speeds duri...
متن کاملPrediction of Chatter in CNC Machining based on Dynamic Cutting Force for Ball End Milling
This paper presents the suitable depth of cut, spindle speed and feed rate that will be chosen during machining. If thus parameters are not considered, this can provoke abnormal tool behavior such as chatter. Chatter will limit the tool life which only can be use for just a few times. To predict the chatter occurs, the parameters will be use are spindle speed, depth of cut and feed rate. CNC ma...
متن کاملChatter Stability Characterization of Full-Immersion End-Milling Using a Generalized Modified Map of the Full-Discretization Method, Part 1: Validation of Results and Study of Stability Lobes by Numerical Simulation
The objective in this work is to generate and discuss the stability results of fully-immersed end-milling process with parameters; tool mass m 0.0431kg, tool natural frequency 5700 rads , damping factor ξ 0 . 0 2 and workpiece cutting coefficient C 3.5 10 Nm ⁄ . Different no of teeth is considered for the end-milling. Both 1-DOF and 2-DOF chatter models of the system are generated on the basis ...
متن کامل