Btanoscale Boehmite Filler for Corrosion- and Wear-resistant Polyphenylenesulfide Coatings
نویسندگان
چکیده
منابع مشابه
Tribo-corrosion of coatings: a review
This paper reviews the available literature relating to the emerging research into the performance of coatings under combined wear and corrosion conditions. Understanding how coatings perform under these tribo-corrosion conditions is essential if the service life of equipment is to be predicted and to allow service life to be extended. Therefore, the tribo-corrosion performance of coatings depo...
متن کاملTribological Properties of LDPE + Boehmite Composites
Tribological properties of composites of low density polyethylene (LDPE) reinforced with 1, 5, 10, 20 wt% micrometric Boehmite (B) and/or preheated Boehmite (HB) powders were studied in combination with two silane coupling agents (SCAs): vinyltri(2-methoxyethoxy)silane (VTMES)-SCA 972 and 3-(trimethoxysilyl)-propylmethacrylate (3MPS)-SCA 989. When coupling agents are used, the samples not subje...
متن کاملThe effect of TiO2 concentration on microstructure, corrosion behavior and wear behavior of Ni-P-W-TiO2 coating
Nickel-phosphorus coatings (Ni-P) are widely used in industry due to their high hardness, corrosion resistance and very good mechanical and chemical properties. Oxide particles such as TiO2 can be used to increase the wear resistance of these coatings. In this study, the Ni-P-W-TiO2 composite coating was deposited on the AISI 304L steel substrate using the electroplating method. Electroplating ...
متن کاملA New Method for Electroplating of Crack-Free Chromium Coatings
In this study, different amounts of MoS2 particles and an anionic surfactant were added to the conventional chromium electroplating bath in order to electrodeposite crack-free chromium coatings and the structure, morphology, tribology and corrosion behavior of the deposited coatings were investigated using X-ray diffraction spectroscopy, scanning electron microscopy, pin on disk ...
متن کاملA comparative study of the wear resistance of thermoplastic and thermoset coatings
Thermoset and thermoplastic polymeric materials are used as coatings on the bore of downhole tubulars such as water injectors in the oil industry. Previous work has indicated that such coatings can fail by impact damage and by abrasion from the wire used to lower inspection tools down the tubular. The wire is commonly called “slickline” and the type of wear is called “wireline wear”. However, t...
متن کامل