Wakefields and HOMs Studies of a Superconducting Cavity Module with the CESR Beam*

نویسندگان

  • S. Belomestnykh
  • W. Hartung
  • G. Flynn
  • J. Kirchgessner
  • H. Padamsee
چکیده

Several aspects of the beam-cavity interaction were investigated in a beam test of the superconducting accelerating cavity module for the CESR upgrade: the time structure of the cavity wake potential, sampled with two bunches, the effect of the module on the total machine loss factor, and the influence of the cavity tuner position on the frequencies and damping times of coupled bunch modes. The spectra of some of higher-order modes excited by the beam were also recorded. The results are discussed.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

The Interaction between a Beam and a Superconducting Cavity Module: Measurements in CESR and CESR-Phase III Goals*

Plans for the next generation of electron-positron colliders (B-factories and B-factory-like machines) call for high beam currents to produce luminosities of the order of 1033. To store these high currents in a machine, special attention must be paid to the interaction of the beam with discontinuities in the surrounding vacuum chamber. RF cavities are among the biggest perturbations in accelera...

متن کامل

Superconducting Rf System for the Cesr Luminosity Upgrade: Design, Status, and Plans*

The CESR Luminosity Upgrade Plan consists of several consecutive steps, or phases [1]. At the present time, this program is in Phase II. The next step, Phase III, would yield a luminosity of 1x1033cm-2sec-1 with 45 bunches in each beam for a total current of 1 A. This plan utilizes four superconducting single-cell cavities with an accelerating gradient of 6 MV/m, which corresponds to a peak acc...

متن کامل

Beam Test of a Superconducting Cavity for the CESR Luminosity Upgrade

ABSTRACT The prototype superconducting cavity system for CESRPhase III was tested in CESR in August 1994. The performance of the system was very gratifying. The cavity operated gradients of 4.5-6 MV/m and accelerated beam currents up to 220 mA. This current is a factor of 3 above the world record 67 mA for SRF[1]. The high circulating beam current did not increase the heat load or present any d...

متن کامل

A Superconducting Landau Accelerator Module for Bessy Ii

The installation of a 3rd harmonic Landau accelerator module is planned at BESSY II to improve the beam lifetime. The passive cavity shall provide an accelerating voltage up to 500 kV for beam currents from 10 to 500 mA. A CESR Phase-III cavity [1], scaled to 1.5 GHz, will be used. The cavity design provides strong damping of higher-order modes by ferrite loads on the beam tubes. A new module, ...

متن کامل

Operating Experience with Superconducting Rf at Cesr and Overview of Other Srf Related Activities at Cornell University

In the two years past since 8 RFSC Workshop the major efforts of the SRF group at Cornell University were concentrated on the completion and commissioning of the superconducting RF system for the Cornell Electron Storage Ring (CESR) e+e− collider [1, 2]. Four singlecell niobium higher-order mode (HOM) damped cavities replaced four 5-cell normal conducting RF cavities. The RF system upgrade bega...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 1995