Relationship between age-related gait adaptations and required coefficient of friction.

نویسندگان

  • Sukwon Kim
  • Thurmon Lockhart
  • Hoon-Yong Yoon
چکیده

A laboratory study was conducted to evaluate if age-related gait adaptations in walking velocity, step length and heel contact velocity could adversely influence friction demand characteristics (i.e. RCOF) and the likelihood of slip initiation. Additionally, relationship between transitional acceleration of the whole body center-of-mass (COM) and friction demand was assessed between young and older participants. Fourteen younger (7 females and 7 males, 18-30 years old) and 14 older (7 females and 7 males, over 65 years old) adults participated in the study. While wearing a safety harness, all participants walked at their preferred gait speed for approximately 20 min on the linear walking track, and synchronized ground reaction forces and posture data were captured using the force plates and six infrared cameras, respectively.The results indicated that older adults walked slower with slower heel contact velocity, and produced lower friction demand (i.e. RCOF) in comparison to younger adults. However, ANCOVA indicated that the differences in heel contact velocity between the two age groups were due to effects of walking velocity. The multiple regression and bivariate regression analyses suggested that, for older adults, heel contact velocity was a predictor for the RCOF, whereas, for younger adults, walking velocity, step length and transitional acceleration of the whole body COM were the factors contributing to the RCOF.In conclusion, the present study suggested that gait adaptations among the elderly must be considered when predicting the likelihood of slip initiation.

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Relationship between hamstring activation rate and heel contact velocity: factors influencing age-related slip-induced falls.

The purpose of this research was to determine whether a decreased hamstring activation rate among the elderly is responsible for a higher horizontal heel contact velocity and increased likelihood of slip-induced falls compared to their younger counterparts. Twenty-eight subjects from two age groups (14 young and 14 old) walked across a linear walking track with embedded force platforms while we...

متن کامل

Effects of quadriceps fatigue on the biomechanics of gait and slip propensity.

This study examines how lower extremity fatigue of the quadriceps alters gait variables related to slip propensity. Sixteen healthy young adults were recruited to walk across vinyl floor surfaces in states of fatigue and no fatigue. Kinematic and kinetic data were collected using a three-dimensional motion analysis system and force plates. The results indicated a significant increase in both th...

متن کامل

Estimation of Friction Coefficient in Sediment Contained Flow through Rockfill

An increase in the flow velocity in flowthrough large porous media and deflection of flow regime from Darcy law causes a nonlinear relationship between hydraulic gradient and pore velocity of media. So many investigations have done previously in such Medias. One of the most important subjects in flowthrough large porous media is relationship between friction coefficient and flow characteristics...

متن کامل

A Low Friction Demanding Approach in Gait Planning for Humanoid Robots During 3D Manoeuvres

This paper proposes a gait planning approach to reduce the required friction for a biped robot walking on various surfaces. To this end, a humanoid robot with 18 DOF is considered to develop a dynamics model for studying various 3D manoeuvres. Then, feasible trajectories are developed to alleviate the fluctuations on the upper body to resemble human-like walking. In order to generate feasible w...

متن کامل

The Relationship between Constant Friction Factor and Coefficient of Friction in Metal Forming using Finite Element Analysis

Frictional shear stress is usually determined by utilizing the coefficient of friction or the constant friction factor models. The present study deals with finite element analysis of double cup extrusion process to determine the relationship between constant friction factor (m) and coefficient of friction (µ), since the metal flow in this process is very sensitive to frictional conditions. Ther...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

عنوان ژورنال:
  • Safety science

دوره 43 7  شماره 

صفحات  -

تاریخ انتشار 2005