Hardware-in-the-Loop Simulation for Verification of the Drive Motor Management Software in a Series Hybrid Electric Bus
نویسندگان
چکیده
Hardware-in-the-Loop (HiL) simulation is known as a reliable approach for testing and verification of the control system of hybrid vehicles. In this paper, a low-cost functional HiL test bench is utilized to test and verify the Drive Motor Management Software (DMMS) in a series hybrid electric bus. The HiL simulator in the current research is a laptop computer where the real-time simulation model of the virtual parts runs on it and the communication with the real hardware is made through high speed CAN. The simulation model is comprised of three subsystems: Energy Storage System (ESS), Traction System (TS) and Vehicle which are designed in LabVIEW environment. The simulation results demonstrate the ability of the designed HiL platform to test and verify the DMMS. Using the designed test bench, all control logics of the DMMS can be evaluated and this will reduce the development costs and time immensely. Keywords— Hardware-in-the-Loop, Hybrid Vehicle, Drive Motor Management Software.
منابع مشابه
Large Lithium Polymer Battery Modeling for the Simulation of Hybrid Electric Vehicles Using the Equivalent Circuit Method
In the present study, a model of a large Lithium Polymer (Li-Po) battery for use in the simulation of Hybrid Electric Vehicles (HEVs) is developed. To attain this goal, an Equivalent Circuit (EC) consisting of a series resistor and two RC parallel networks is considered. The accuracy and the response time of the model for use in an HEV simulator are studied. The battery parameters identifica...
متن کاملRobust Controller Design Based-on Aerodynamic Load Simulator Identification Driven by PMSM for Hardware-in-the-Loop Simulations
Aerodynamic load simulators generate the required time varying load to test the actuator’s performance in the laboratory. Electric Load Simulator (ELS) as one of variety of the dynamic load simulators should follows the rotation of the Under Test Actuator (UTA) and applies the desired torque to UTA’s rotor at the same time. In such a situation, a very large torque is imposed to the ELS from the...
متن کاملModel Based Design approach for Implementation of PHEV Energy Management
Hardware implementation of the Plug-in hybrid electric vehicles (PHEVs) control strategy is an important stage of the development of the vehicle electric control unit (ECU). This paper introduces Model-Based Design (MBD) approach for implementation of PHEV energy management. Based on this approach, implementation of the control algorithm on an electronic hardware is performed using automatic co...
متن کاملBattery and generator sizing of series hybrid electric vehicle based on experimental data and standard cycles simulation
Hybrid electric vehicles are getting more attention due to the fuel consumption and emission issue in megacities. Energy management strategy and battery capacity are the primary factors for the energy efficiency of range-extended hybrid electric vehicles. Iran khodro Powertrain Company has unveiled a series of hybrid electric vehicles and is improving its performance constantly. In the present ...
متن کاملDesign of an anti-lock regenerative braking system for a series hybrid electric vehicle
In this paper, an adaptive rule based controller for an anti-lock regenerative braking system (ARBS) of a series hybrid electric bus (SHEB) has been proposed. The proposed controller integrates the regenerative braking and wheel anti-lock functions by controlling the electric motor of the hybrid vehicle, without using any conventional mechanical anti-lock braking system. The performance of the ...
متن کامل