Nucleation rates of methanol using the SAFT-0 equation of state.
نویسندگان
چکیده
Classical and nonclassical calculations of nucleation rates are presented for methanol, an associating vapor system. The calculations use an equation of state (EOS) that accounts for the effects of molecular association based on the statistical association fluid theory (SAFT). Two forms of classical nucleation theory (CNT) were studied: a Gibbsian form known as the P-form and the standard or S-form. CNT P-form calculations and nonclassical gradient theory (GT) calculations were made using the SAFT-0 EOS. Calculated rates were compared to the experimental rates of Strey, et al. [J. Chem. Phys. 1986, 84, 2325-2335]. Very little difference was found between the two forms of CNT for either the temperature (T) or supersaturation (S) dependence of the rates. Nucleation rates based on GT showed improved T and S dependence compared to CNT. The GT rates were also improved by factors of 100-1000 compared to CNT. Despite these improvements, GT does not describe the reported T and S dependence of the nucleation rates. To explore this further, the GT and experimental rates were analyzed using Hale's scaled model [J. Chem. Phys. 2005, 122, 204 509]. This analysis reveals an inconsistency between the predictions of GT, which scale relatively well, and the experimental data, which do not scale. It also shows that the measured rate data have an anomalous T and S dependence. A likely source of this anomaly is the inadequate thermodynamic data base for small cluster properties that was used originally to correct the raw rate data for the effects of association.
منابع مشابه
Predictions of the Joule-Thomson Inversion Curve for Water and Methanol from the LJ-SAFT EOS
In this work, we have calculated the Joule-Thomson inversion curve of two important associating fluids, namely water and methanol, from the SAFT equation of state. Comparisons with the available experimental data, for water and methanol indicate that this molecular based equation of state gives good prediction of the low temperature branch; but, unfortunately, due to lack of isenthalpic dat...
متن کاملModeling thermodynamic properties of electrolytes: Inclusion of the mean spherical approximation (MSA) in the simplified SAFT equation of state
In this work, an equation of state has been utilized for thermodynamic modeling of aqueous electrolyte solutions. The proposed equation of state is a combination of simplified statistical associating fluid theory (SAFT) equation of state (similar to simplified PC-SAFT) to describe the effect of short-range interactions and mean spherical approximation (MSA) term to describe the effect of long-r...
متن کاملObservations of Sludge Formation in Group I Base Stock for Lubricants and Thermodynamic Modeling with the SAFT Equation of State
Varnish and sludge formation are considered as one of the most common problems in lubrication and hydraulic systems. In order to simulate the condition of sludge formation, base stock lubricant (Group 1 API) has been selected and exposed to heat in a laboratory setup. Sludge formation process accelerated in the laboratory scale and solid liquid equilibrium data were extracted. Then solid-liquid...
متن کاملMinimum Miscibility Pressure Using the Multiple Mixing-cell Combined with the PC-SAFT Equation of State
The minimum miscibility pressure (MMP) is one of the crucial and substantial parameters in the gas injection projects for enhanced oil recovery (EOR). This parameter indicates the minimum pressure at constant temperature and composition conditions for reaching 100 percent of the oil production recovery which leads to a huge economic income. Therefore, an inaccurate prediction of the MMP may lea...
متن کاملModeling Solubility Behavior of CO2 in [C2-mim][BF4] and [C4-mim][BF4] Ionic Liquids by sPC-SAFT Equation of State
The simplified perturbed chain statistical associating fluid theory (sPC-SAFT) Equation of State (EOS) was proposed to describe the thermodynamic properties of pure ionic liquids (ILs). A set of sPC-SAFT parameters for 2 ILs was obtained by fitting the experimental liquid densities data over a wide range of temperature at atmospheric pressure. Good agreement with experimental density data was o...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید
ثبت ناماگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید
ورودعنوان ژورنال:
- Chemphyschem : a European journal of chemical physics and physical chemistry
دوره 11 18 شماره
صفحات -
تاریخ انتشار 2010