An in vitro investigation of the dependence on sample thickness of the speed of sound along the specimen.

نویسندگان

  • C F Njeh
  • D Hans
  • C Wu
  • E Kantorovich
  • M Sister
  • T Fuerst
  • H K Genant
چکیده

To measure the speed of sound (SOS), most quantitative ultrasound (QUS) devices use the transmission mode, whereby two transducers are placed on opposite sides of the sample. This mode is limited to a few specific skeletal sites because of the varying configuration of bone geometry and varying amounts of overlying soft tissue at most other sites. The aim of this study was to address the dependence of SOS measured along the sample on the thickness and composition of the bone sample. Bovine samples from mid-femur and trochanter, and perspex phantoms were used. We prepared the perspex samples in the shapes of blocks and cylinders to investigate the effect of wall thickness on SOS. The thickness of the blocks was decreased in decrements of 1 mm; a 22 mm diameter hole was drilled through the cylindrical samples and the hole size was gradually increased. The second configuration was also used with the bovine samples. For each experimental set-up five SOS measurements were acquired, with the probe aligned along the sample and a mean value computed. All measurements were taken with castor oil as the coupling agent, and in the cylindrical cases, the oil was used to fill the tube. The measurement precision determined as the root mean square coefficient of variation (RMSCV) was determined to be 0.14% and 0.65% for perspex and bovine samples respectively. The measured SOS on the perspex phantom (2760+/-4 m/s) was within the published values for bulk velocity. It was observed that for both perspex and bovine samples the SOS was independent of sample wall thickness greater than the wavelength (2.2 mm, 2.7 mm and 3.5 mm for perspex, trochanter and mid-femur respectively). The SOS decreased with sample wall thickness smaller than the wavelength in concordance with theoretical predictions. The SOS values obtained for bovine samples reflected either totally cortical (mid-femur) or a composite of cortical and cancellous bone (trochanter).

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Effect of Different Enamel Preparation Methods on Microleakage of Fissure Sealant: An In Vitro Study

Objective: Lack of a dental material with optimal adhesion and sealability is an important challenge in modern dentistry leading to marginal leakage. There are controversies on the necessity of enamel preparation in pit and fissure sealant therapy and its effect on decreasing the microleakage therefore, the present in vitro study aimed to assess the amount of microleakage with and without ename...

متن کامل

In vitro effect of fiber reinforcement on fracture resistance of incisal edge composite restorations

Objective: Introduction of fiber-reinforced composites (FRC) greatly enhanced the restoration of fractured anterior teeth. The purpose of this study was to assess the effect of fiber reinforcement on fracture resistance of incisal edge composite restorations of variable thicknesses. Methods: Forty extracted sound human maxillary incisors were divided into four groups of 10. Incisal reduction wa...

متن کامل

An investigation of reactive behavior of yellowfin tuna schools to the purse seining process

The movement parameters of yellow fin tuna schools were analyzed by means of scanning sonar in tuna purse seine capture situations in the Oman Sea in June 2010. There was significant difference in swimming speed and radial swimming direction between the escaped and captured schools. In escaped cases, the fish schools swam faster with mostly horizontal avoidance behavior to the sound stimuli fro...

متن کامل

TEM INVESTIGATION OF RAPIDLY SOLIDIFIED NDFEB HARD MAGNETIC MATERIAL

The surface condition and microstructure of near stoichiometric (Fe823Ndll.8B5.9) Nd-Fe-B alloy ribbons and the effect of melt spinning parameters were investigated using optical, scanning and transmission electron microscopes (SEM, TEM). The formation of gas pockets on the roll surface of the ribbons during melt spinning can prevent heat transform and result in local coarse grains. The local t...

متن کامل

Investigation of the effect of electrolyte on acoustical behaviour of ceramic coatings produced by method Plasma Electrolytic Oxidation (PEO) on titanium

In this paper, titanium oxide coating (TiO2) was produced on titanium alloy Ti6Al4V by Plasma Electrolytic Oxidation (PEO) Method. Sodium Silicate (Na2SiO3) and Sodium Aluminate (NaAlO2) based electrolytes were selected in PEO process. The effects of concentration of Sodium Aluminate (0, 2.5, 5, 7.5, and 10 g/L) on the microstructure and acoustical behaviour of the formed coatings were studied....

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:
  • Medical engineering & physics

دوره 21 9  شماره 

صفحات  -

تاریخ انتشار 1999