Solving the problems with traditional Silicon Controlled Rectifier (SCR) approaches for ESD
نویسندگان
چکیده
The Silicon Controlled Rectifier (‘SCR’) is widely used for ESD protection due to its superior performance and clamping capabilities. However, many believe that SCR based ESD protection is prone to latch-up, competitive triggering, long development cycles and slow trigger speed. This paper provides an overview of the problems and corresponding design solutions available.
منابع مشابه
Electrical Characteristics of SCR - based ESD Device for I/O and Power Rail Clamp in 0.35um Process
This paper presents a SCR-based ESD protection devices for I/O clamp and power rail clamp, respectably. These devices have a low trigger voltage and high holding voltage characteristics than conventional SCR device. These devices are fabricated by using 0.35um BCD (Bipolar-CMOS-DMOS) processes. These devices were validated using a TLP system. From the experimental results, the device for I/O ES...
متن کاملSCR Device With Double-Triggered Technique for On-Chip ESD Protection in Sub-Quarter-Micron Silicided CMOS Processes
Turn-on efficiency is the main concern for silicon-controlled rectifier (SCR) devices used as on-chip electrostatic discharge (ESD) protection circuit, especially in deep sub-quarter-micron CMOS processes with much thinner gate oxide. A novel double-triggered technique is proposed to speed up the turn-on speed of SCR devices for using in on-chip ESD protection circuit to effectively protect the...
متن کاملLow-Capacitance and Fast Turn-on SCR for RF ESD Protection
With the smaller layout area and parasitic capacitance under the same electrostatic discharge (ESD) robustness, silicon-controlled rectifier (SCR) has been used as an effective on-chip ESD protection device in radio-frequency (RF) IC. In this paper, SCR's with the waffle layout structures are studied to minimize the parasitic capacitance and the variation of the parasitic capacitance within ult...
متن کاملSubstrate-Triggered SCR Device for On-Chip ESD Protection in Fully Silicided Sub-0.25- m CMOS Process
The turn-on mechanism of a silicon-controlled rectifier (SCR) device is essentially a current triggering event. While a current is applied to the base or substrate of the SCR device, it can be quickly triggered into its latching state. In this paper, a novel design concept to turn on the SCR device by applying the substrate-triggered technique is first proposed for effective on-chip electrostat...
متن کاملDummy-Gate Structure to Improve Turn-on Speed of Silicon-Controlled Rectifier (SCR) Device for Effective Electrostatic Discharge (ESD) Protection
Turn-on speed is the main concern for on-chip electrostatic discharge (ESD) protection device, especially in deep submicron complementary metal-oxide semiconductors (CMOS) processes with ultra-thin gate oxide. A novel dummy-gate-blocking silicon-controlled rectifier (SCR) device with substrate-triggered technique is proposed to improve the turn-on speed of SCR device for using in on-chip ESD pr...
متن کامل