Emission Sampling and Analysis
نویسنده
چکیده
1. Survey 1.1. Characteristics to be analyzed 1.2. Concentration Units 1.3. Presentation of Analytical Results 1.4. Quality of Analyses 1.5. Analytical Procedures 2. Flue Gas Sampling 2.1. Sampling Effluents 2.2. Organic Micropollutants Sampling 2.3. Gas Sampling Train 2.4. Sampling of Inorganic Compounds 3. Gas Analyzers 3.1. Survey 3.2. Gas Chromatographic Separation 3.3. Gas Chromatographic Detectors 3.3.1. Survey 3.3.2. Flame Ionization Detector (FID) 3.3.3. Thermal conductivity detector (TCD) 3.3.4. Electron Capture Detectors (ECD) 3.3.5. Flame Photometric Detectors (FPD) 3.3.6. Photo-Ionization Detectors (PID) 3.4. Mass Spectrometers (MS) 4. Conclusions Glossary Bibliography Biographical Sketches
منابع مشابه
Application of Life Cycle Assessment for Techno-Economic Evaluation of Rural Solid Waste Management Strategies: Significance of CO2 Emission Control from Waste Management Sector in Abyaneh Village, Isfahan Province
Waste disposal in the current situation, which quantity and variety of waste are increasing, needs not only effective management principles but also depends on environmentally-friendly methods to put as less environmental footprint as possible. This study aims to assess the energy consumption, emission of greenhouse gases and air pollutants which normally produce during various waste management...
متن کاملA Preliminary Particulate Matter Emission Factor from Cotton Harvesting
Particulate matter (PM) sampling of cotton harvesting operations at three locations in Texas was conducted during the summer of 2006. PM emissions generated by a two-row (John Deere model 9910) and six-row (John Deere model 9996) cotton picker were measured at each sampling location. The PM emissions from the two-row and sixrow machines were measured using a protocol employing collocated low vo...
متن کاملشناسایی منابع انتشار هیدروکربن های آروماتیک چندحلقه ای ذرات PM10 هوای شهر تهران در سال 92
Background and Objective: Polycyclic aromatic hydrocarbons (PAHs) are a group of organic pollutants that are mostly generated during the incomplete combustion. The main objective of this study was to characterize potential sources of PAHs in Tehran. Materials and Methods:, Samples of PM10 were collected at 10 monitoring stations belonging to Tehran Air Quality Control Company (AQCC) and tran...
متن کاملGearbox Tooth Cut Fault Diagnostics Using Acoustic Emission and Vibration Sensors — A Comparative Study
In recent years, acoustic emission (AE) sensors and AE-based techniques have been developed and tested for gearbox fault diagnosis. In general, AE-based techniques require much higher sampling rates than vibration analysis-based techniques for gearbox fault diagnosis. Therefore, it is questionable whether an AE-based technique would give a better or at least the same performance as the vibratio...
متن کاملMatrix-Assisted Plasma Atomization Emission Spectrometry for Surface Sampling Elemental Analysis
An innovative technology has been developed involving a simple and sensitive optical spectrometric method termed matrix-assisted plasma atomization emission spectrometry (MAPAES) for surface sampling elemental analysis using a piece of filter paper (FP) for sample introduction. MAPAES was carried out by direct interaction of the plasma tail plume with the matrix surface. The FP absorbs energy f...
متن کاملCluster Analysis of Acoustic Emission Signals for Carbon/Epoxy Composite in Four-point Bending Test (RESEARCH NOTE)
Due to the extensive use of composites in various industries and the fact that defects reduce ultimate strength and efficiency during operation, detection of failures in composite parts is very important. The aim of this paper is to use Acoustic Emission (AE) non-destructive method in four-point bending test of carbon/epoxy composite to analyze and examine the failure mechanisms. This method is...
متن کامل