Aging effect on the tribological behavior of a Novel 3Y-TZP/Nb Biocomposite against Ultra High Molecular Weight Polyethylene (UHMWPE)

نویسندگان

  • C. F. Gutiérrez-González
  • A. Smirnov
  • J. F. Bartolomé
چکیده

The aim of this study was to evaluate the friction and wear behavior of ultra high molecular weight polyethylene (UHMWPE) against 3Y-TZP and a novel 3Y-TZP/niobium (Nb) biocomposite. The ceramic and the biocomposite materials were subjected to an accelerated aging process to evaluate the changes in the tribological behavior after this treatment. To carry out the tribological tests, a reciprocating pin-on-flat contact configuration was used. The results show a lower friction coefficient and wear rate for 2 biocomposite/UHMWPE couples than for 3Y-TZP/UHMWPE couples. The present study demonstrates that the excellent wear properties of this new biocomposite should never be influenced by aging. Based on these data, the potential of zirconia-Nb as an alternative bearing biomaterial is discussed.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Investigation of Wear Behavior of Biopolymers for Total Knee Replacements Through Invitro Experimentation

The average life span of knee prosthesis used in Total Knee Replacement (TKR) is approximately 10 to 15 years. Literature indicates that the reasons for implant failures include wear, infection, instability, and stiffness. However, the majority of failures are due to wear and tear of the prosthesis. The most common biopolymer used in TKR  is Ultra High Molecular Weight Polyethylene (UHMWPE). Pr...

متن کامل

Synthesis and Tribological Behavior of Ultra High Molecular Weight Polyethylene (UHMWPE)-Lignin Composites

In this paper, we report the synthesis and characterization of ultra-high molecular weight polyethylene (UHMWPE)-lignin composites. During this study four different compositions, namely UHMWPE, UHMWPE-13 wt. % lignin, UHMWPE-25 wt. % lignin and UHMWPE-42.5 wt. % lignin were fabricated by hot pressing. Detailed microstructural studies by scanning electron microscopy (SEM) showed that UHMWPE and ...

متن کامل

Biotribological behavior of Ag-ZrCxN1-x coatings against UHMWPE for joint prostheses devices.

This study aims to evaluate the structural, mechanical and tribological properties of zirconium carbonitrides (ZrCxN1-x) coatings with embedded silver nanoparticles, produced with the intention of achieving a material with enhanced multi-functional properties, including mechanical strength, corrosion resistance, tribological performance and antibacterial behavior suitable for their use in joint...

متن کامل

Tribological characterization of a biocompatible thin film of UHMWPE on Ti6Al4V and the effects of PFPE as top lubricating layer.

Ultra-high molecular weight polyethylene (UHMWPE) thin film was coated onto Ti6Al4V alloy specimens using dip coating method. Tribological performance of this coating (thickness of 19.6 ± 2.0 μm) was evaluated using 4 mm diameter Si(3)N(4) ball counterface in a ball-on-disk tribometer. Tests were carried out for different normal loads (0.5, 1.0, 2.0 and 4.0 N) and rotational speeds of the disk ...

متن کامل

Macrophage Response to UHMWPE Submitted to Accelerated Ageing in Hydrogen Peroxide

Ultra-high molecular weight polyethylene (UHMWPE) has been the most commonly used bearing material in total joint arthroplasty. Wear and oxidation fatigue resistance of UHMWPE are regarded as two important properties to extend the longevity of knee prostheses. The present study investigated the accelerated ageing of UHMWPE in hydrogen peroxide highly oxidative chemical environment. The sliced s...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2013