Analysis, Design and Control of Zero Current Switching DC To DC Buck Converter
نویسندگان
چکیده
A soft-switching buck converter is proposed for battery charging application. This converter can also be used with other low voltage miniature applications. Resonant inductor and capacitor helps to turn on-off the switch at zero current. This reduces switching losses in our conventional converter. In order to determine two (current) zero-cross points for switch-on and switch-off, the quasi-resonant state is employed. The quasi-resonant state is performed in fullwaveform mode. This makes output voltage independent of output load variation. This leads to efficiency higher than conventional converter due to ZCS. Complete design-oriented mathematical calculations were done for zero current resonant switching converters. The performance of the proposed converter is evaluated on a 3.24-W (6 V/0.54 A) experimental prototype.
منابع مشابه
Simulation and Experimental Verification of Closed Loop Operation of Buck / Boost DC-DC Converter with Soft Switching
A major problem in an isolated DC/DC converters operating at high switching frequencies is the attendant switching losses in the semiconductor devices. This can be reduced by introducing either zero-voltage switching (ZVS) or zero-current switching (ZCS) of the semiconductor switches. This paper deals with the simulation, design, fabrication and experimental evaluation of a novel soft-switching...
متن کاملA New Topology of Bidirectional Buck-Boost dc/dc Converter with Capability of Soft Switching and input Current Ripple Cancellation
In this paper, a new bidirectional buck-boost dc-dc converter with capability of soft switching and zero input current ripple is proposed. The coupled inductor is used in the proposed converter to eliminate the input current ripple. In the proposed converter, zero voltage switching (ZVS) and zero current switching (ZCS) can be obtained for the main and auxiliary switches, respectively. In addit...
متن کاملA High Efficiency Low-Voltage Soft Switching DC–DC Converter for Portable Applications
This paper presents a novel control method to improve the efficiency of low-voltage DC-DC converters at light loads. Pulse Width Modulation (PWM) converters have poor efficiencies at light loads, while pulse frequency modulation (PFM) control is more efficient for the same cases. Switching losses constitute a major portion of the total power loss at light loads. To decrease the switching losses...
متن کاملSliding Mode Control of a Bidirectional Buck/Boost DC-DC Converter with Constant Switching Frequency
In this paper, sliding mode control (SMC) for a bidirectional buck/boost DC-DC converter (BDC) with constant frequency in continuous conduction mode (CCM) is discussed. Since the converter is a high-order converter, the reduced-order sliding manifold is exploited. Because of right-half-plan zero (RHPZ) in the converter’s duty ratio to output voltage transfer function, sliding mode current...
متن کاملA Soft Switched DC-DC Boost Converter for Use in Grid Connected Inverters
This paper presents a soft-switching DC-DC boost converter, which can be utilized in renewable energy systems such as photovoltaic array, and wind turbine connections to infinite bus of a big power network, using grid connected inverters. In the proposed topology for the DC-DC boost converter, the main and the auxiliary power switches are turned on and turned off with zero voltage switching (ZV...
متن کاملAnalysis and Design of a New Single Switch Non-Isolated Buck-Boost dc-dc Converter
In this paper, a new transformerless buck-boost converter based on ZETA converter is introduced. The proposed converter has the ZETA converter advantages such as, buck-boost capability and input to output DC insulation. The suggested converter voltage gain is higher than the classic ZETA converter. In the presented converter, only one main switch is utilized. The proposed converter offers low v...
متن کامل