Transport properties of Ni81.5B18.5 - YP y amorphous alloys
نویسندگان
چکیده
The thermoelectric power of the amorphous nonmagnetic alloy system Ni81.5B18.5-yPy (y = 0, 1.8, 3.7, 7.4, 13, 16.8 and 18.5 at % P) has been investigated in the temperature range between 77 and 350 K. The resistivity and temperature coefficient of resistivity have also been measured. The high temperature slope of the thermopower, the resistivity and the room temperature coefficient of resistivity are simultaneously explained within the framework of the extended Ziman model. In performing the corresponding calculations we have chosen the phase shifts in a such a way that they reflect the d-band filling on alloying (deduced from the specific heat measurements). An unexpectedly large negative thermopower is obtained for the boron rich alloys. A possible origin of a « giant » contribution to the thermopower of these alloys is discussed. J. Phys. France 50 (1989) 3233-3242 1er NOVEMBRE 1989,
منابع مشابه
Effect of Ni on Amorphization of Ti-Cu-Ni Ternary alloys Prepared by Mechanical alloying
Amorphous alloys has been taken into consideration because of their unique properties and are nominated as the future engineering materials. In this research, the effect of Ni and milling time on amorphization process and thermal stability of Ti50Cu50-xNix(x=10, 15, 25 at%) alloy system were investigated. The evolution of amorphization during milling, thermal stability and subsequent heat treat...
متن کاملMAGNETIC PROPERTIES OF AMORPHOUS Fe-Ti ALLOYS PRODUCED BY FACING TARGET TYPE SPUTTERING
In bulk FeTi alloys prepared by facing target type sputtering, an amorphous phase was obtained between 25 and 75 at% Ti. These alloys are weak itinerant electron ferromagnets and the Curie temperature decreases with increasing Ti concentration and becomes zero at about 60 at% Ti.
متن کاملTRANSPORT AND MAGNETIC PROPERTIES OF (Fe100-xVx)75 P15C10 AMORPHOUS ALLOYS
(Fe100-xVx)75P15C10 (x = 0, 5, 10 and 15) amorphous alloys in the form of ribbon were prepared by the standard melt spinning technique and studied their transport and magnetic properties. The resistivity follows ‘Mooij correlation’ at low temperature (300 93) K. The Hall resistivity and the magnetoresistance (MR) were measured in an applied magnetic field up to 0.6T at room temperature (RT = 30...
متن کاملar X iv : c on d - m at / 9 51 10 21 v 1 3 N ov 1 99 5 Calculation of electronic properties of amorphous alloys
We describe the application of the locally-self-consistent-multiple-scattering (LSMS)[1] method to amorphous alloys. The LSMS algorithm is optimized for the Intel XP/S-150, a multiple-instruction-multiple-data parallel computer with 1024 nodes and 2 compute processors per node. The electron density at each site is determined by solving the multiple scattering equation for atoms within a specifi...
متن کاملEffect of P addition on nanocrystallization and high temperature magnetic properties of low B and Nb containing FeCo nanocomposites
The P content dependencies of the nanocrystallization behaviors and high temperature magnetic properties of the Fe 54.6 Co 29.4 Si 2.8 (B 0.8ÀY P Y) 14 Nb 1 Cu 1 (Y ¼ 0, 0.2, and 0.3) alloys have been investigated. Alloys were prepared by melt spinning and subsequently annealed in an argon atmosphere to induce nanocrystallization. P addition increases primary crystallization temperature (Tx 1),...
متن کامل