Independent control of beam astigmatism and ellipticity using a SLM for fs-laser waveguide writing.
نویسندگان
چکیده
We have used a low repetition rate (1 kHz), femtosecond laser amplifier in combination with a spatial light modulator (SLM) to write optical waveguides with controllable cross-section inside a phosphate glass sample. The SLM is used to induce a controllable amount of astigmatism in the beam wavefront while the beam ellipticity is controlled through the propagation distance from the SLM to the focusing optics of the writing set-up. The beam astigmatism leads to the formation of two separate disk-shaped foci lying in orthogonal planes. Additionally, the ellipticity has the effect of enabling control over the relative peak irradiances of the two foci, making it possible to bring the peak irradiance of one of them below the material transformation threshold. This allows producing a single waveguide with controllable cross-section. Numerical simulations of the irradiance distribution at the focal region under different beam shaping conditions are compared to in situ obtained experimental plasma emission images and structures produced inside the glass, leading to a very satisfactory agreement. Finally, guiding structures with controllable cross-section are successfully produced in the phosphate glass using this approach.
منابع مشابه
Using of Broadened Asymmetric Waveguide Structure for 980nm Diode Laser
Laser diode beam divergence is the main parameter for beam shaping and fiber optic coupling. Increasing the waveguide layer thickness is the conventional method to decrease the beam divergence. In this paper, the broadened asymmetric waveguide is introduced to decrease the divergence without increasing the optical power. The asymmetric waveguide was used to shift the vertical optical field to n...
متن کاملFemtosecond fiber laser direct writing of optical waveguide in glasses
There is a great deal of interests and efforts in the area of femtosecond (fs) laser direct writing of transparent materials, which shows promise to be a powerful and flexible technique for rapid fabrication of photonic micro-device, such as gratings, waveguides and optical amplifiers. Waveguide properties depend critically on the sample material properties and writing laser characteristics. In...
متن کاملA simple but precise method for quantitative measurement of the quality of the laser focus in a scanning optical microscope
We report a method for characterizing the focussing laser beam exiting the objective in a laser scanning microscope. This method provides the size of the optical focus, the divergence of the beam, the ellipticity and the astigmatism. We use a microscopic-scale knife edge in the form of a simple transmission electron microscopy grid attached to a glass microscope slide, and a light-collecting op...
متن کاملImproving the Thermal Characteristics of Semiconductor Lasers Using a New Asymmetric Waveguide Structure
Self-heating leads to a temperature rise of the laser diode and limits the output power and efficiency due to increased loss and decreased differential gain. To control device self-heating, it is required to design the laser structure with a low optical loss, while the heat flux must spread out of the device efficiently. In this study, a new asymmetric waveguide design is proposed and th...
متن کاملBeam divergence and waist measurements of laser diodes by near- eld scanning optical microscopy
We demonstrate the use of neareld scanning optical microscopy (NSOM) for the measurement of the beam properties of SQW-GRINSCH ridge laser diodes. Using NSOM, we measure the eld intensity in the transverse plane at neareld and as a function distance from the facet. The divergence of the laser beam and the beam waists in vertical and lateral dimensions are directly measured and the astigmatism o...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید
ثبت ناماگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید
ورودعنوان ژورنال:
- Optics express
دوره 17 23 شماره
صفحات -
تاریخ انتشار 2009