Load Current Control Based on Luenberger Observer for Three Phase Power Converter Svpwm

نویسنده

  • HERY PURNOMO
چکیده

This paper presents Load Current Control based on Luenberger Observer for Three-Phase Power Converter SVPWM with current regulation. The use of observer is intended to replace the use of dc current sensor, so it eliminates the nonlinearity problem and drop voltage caused the sensor. This research develops a controller to improve the time response of the dc output voltage of the three-phase power converter based on load current estimation. The simulation results show that overshoot the output voltage on load change from full load to 50% full load is about 3% with settling time 0.03 sec. .

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Design and Simulation of a New DC Power Supply Based on Dual Bridge Matrix Converter

A conventional high power DC power supply systems consist of a three-phase diode rectifier followed by a high frequency converter to supply loads at regulated DC voltage. These rectifiers draw significant harmonic currents from the utility, resulting in poor input power factor. In this paper, a DC power supply based on dual-bridge matrix converter (DBMC) with reduced number of switches is p...

متن کامل

Implementation of SVPWM control on FPGA for three phase MATRIX CONVERTER

This paper presents a simple approach for implementation of a Space Vector Pulse Width Modulation (SVPWM) Technique for control of three phase Matrix Converter (MC) using MATLAB/Simulink & FPGA Software. The Matrix converter is a direct AC/AC Power conversion without an intermediate DC link. This converter is inherently capable of bi-directional power flow and also offers virtually sinusoidal i...

متن کامل

A Novel Implementation of Switching Reduction in Single Phase to Three Phase Converter

In this implementation consists two single-phase to three-phase conversion systems for a three-phase load application. The load is connected to a single-phase grid through an ac–dc–ac single-phase to three-phase converter. The single-phase rectifier is composed of two parallel single-phase half-bridge rectifiers. The main objective of this design is based on number of switching devices is reduc...

متن کامل

Comparative Power Quality Analysis of Different DSTATCOM Topologies

This paper presents the three topologies of three-phase four-wire DSTATCOM for reduction of harmonics, reactive power compensation, increasing power factor, which occur due to a nonlinear load, environment problem and polluted grid. The performances of the above topologies have been compared for the magnitude of source current, power factor improvement, DC-link voltage regulation, and total har...

متن کامل

Voltage Control and Load Sharing in a DC Islanded Microgrid Based on Disturbance Observer

Increasing DC loads along with DC nature of distributed energy resources (DERs) raises interest to DC microgrids. Conventional droop/non-droop power-sharing in microgrids suffers from load dependent voltage deviation, slow transient response, and requires the parameters of the loads, system and DERs connection status. In this paper, a new nonlinear decentralized back-stepping control strategy f...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2013