A study on crown and bridge resin using PNC-EMA monomer.
نویسندگان
چکیده
The present study investigated the development of crown and bridge resin using a new PNC-EMA monomer. M MA monomer has long been used for crown and bridge resins, but the polymer prepared with MMA monomer has certain demerits such as low mechanical strength and abrasion resistance. The authors prepared a polymer by mixing 3PNC-EMA monomer having a P=N bond in its skeleton, previously synthesized by ANZAI et al., with a monomer currently available
منابع مشابه
Comparative Evaluation of the Flexural Strength of Heat Polymerized Acrylic Resin with the Addition of 8% and 13% Aluminum Oxide Powder: An In-vitro Study
Introduction: Acrylic resins have been used successfully as denture bases. However, acrylic resin denture base materials are brittle and have poor strength and thermal conductivity. Therefore, it is essential to improve the flexural strength of heat polymerized acrylic resin. The present study aimed to evaluate and compare the flexural strength of heated polymerized acrylic res...
متن کاملShort glass fiber-reinforced composite with a semi-interpenetrating polymer network matrix for temporary crowns and bridges.
AIMS The purpose of this study was to investigate the reinforcement effect of short E-glass fiber fillers on some mechanical properties of temporary crown and bridge (TCB) composite resin with a semi-interpenetrating polymer network (semi-IPN). METHODS AND MATERIALS Experimental temporary fiber reinforced (TFC) composite resin was prepared by mixing 15 wt% of short E-glass fibers (3 mm in len...
متن کامل[Relationship among the composition and the physical and chemical properties of photo-cured composites for crown and bridge].
In this study, the relationship among the chemical composition and the physical and chemical properties of four photo-cured composites and one heat curing composite for crown and bridge were investigated. Five composites were composed of the base monomer, UDMA, TriEGDMA, 1, 3-BDMA, 1, 4-BDMA, 1, 10-DDMA, 1, 12-DDDMA or those mixture, and the composite-filler consist of the resin (TMPTMA, UDMA, ...
متن کاملKinetic Study of Graft Polymerization of Acrylic Acid and Ethyl Methacrylate onto Starch by Ceric Ammonium Nitrate
Graft polymerization of acrylic acid (AA) and ethyl methacrylate (EMA) onto starch (St) were carried out in aqueous solution using ceric ammonium nitrate (CAN) as redox system under N2 atmosphere. The effect of pH, reaction time, temperature, concentrations of CAN, St, and monomers on the graft yield was investigated. Monomer reactivity was in the following order: AA>EMA.<em...
متن کاملA comparison of two different methods and materials used to repair polycarbonate crowns.
AIM The aim of this study was to evaluate the bond strength and crown-repair material interface of polycarbonate crown repaired using flowable resin composite and hybrid resin composite following two different surface preparations. METHODS AND MATERIALS The facial surfaces of fifty-two polycarbonate crowns were flattened and roughened. Specimens were then divided into four test groups. A bond...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید
ثبت ناماگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید
ورودعنوان ژورنال:
- The Journal of Nihon University School of Dentistry
دوره 28 4 شماره
صفحات -
تاریخ انتشار 1986