Direct Numerical Simulation of an Accelerating Channel Flow

Direct Numerical Simulation of a linearly accelerating channel flow starting from an initially statistically steady turbulent flow has been performed. It is shown that the response of the accelerating flow is fundamentally the same as that of the step-change transient flow described in He and Seddighi (J Fluid Mech 715:60–102, 2013). The flow structure again behaves like a boundary layer bypass transition undergoing three distinct phases, namely, (i) initially (pre-transition), the flow is laminar-like and the pre-existing turbulent structures are modulated resulting in elongated streaks leading to a strong and continuous increase in the streamwise fluctuating velocity but little changes in the other two components; (ii) it then undergoes transition when isolated turbulent spots are generated which spread and merge with each other, and (iii) they eventually cover the entire surface of the wall when the flow is fully turbulent. The similarity between the turbulence responses in the two flows is significant noting the contrasting features of the two types of mean flow unsteadiness: in the step-change flow, a sharp boundary layer is resulted in nearly instantly on the wall which closely resembles the spatially developing boundary layer, whereas the linear flow acceleration causes a continuing change of velocity gradient adjacent to the wall which propagates into the flow field with time, resulting in a gradually-developing boundary layer. There are, however, quantitative differences M. Seddighi · S. He (B) Department of Mechanical Engineering, University of Sheffield, Sheffield, S1 3JD, UK e-mail: [email protected] A. E. Vardy Division of Civil Engineering, University of Dundee, Dundee, DD1 4HN, UK P. Orlandi Dipartimento di Meccanica e Aeronautica, Universita’ di Roma “La Sapienza”, Rome, Italy Flow Turbulence Combust in the detailed behavior of the two flows and especially the transition is much delayed in the accelerating flow. It is also shown that the late pre-transition and early transition stages in both flows are characterised by significantly increased inwards sweep events in the wall region and ejection events in the outer layer. The flatness of the wall-normal velocity increases markedly near the wall around the time of onset of transition as a consequence of the huge intermittency of the velocity fluctuations. That is, there are long periods of quiescent flow coupled with occasional turbulent bursts.