Determination of Permeability from Impedance Measurement Using Vector Network Analyzer
نویسنده
چکیده
This study treats the optimised one-port (reflection coefficient) and two-port (shunt-through/series-through) measurement methods for complex permeability determination of solid soft magnetic materials using a vector network analyzer (VNA) at frequencies from 9 kHz to 6.5 GHz. The principle of measurement methods, the relationships of measured phasor voltage ratio (Sparameter) to complex impedance, and permeability calculation equations are presented. Each method gives good measurement sensitivity at the impedance range where the measured ac voltage at the VNA’s receiver significantly varies. For permeability evaluation, the shunt-through method provides the best sensitivity and stability and thus is suitable for both low and high permeability materials.
منابع مشابه
Permeability estimation from the joint use of stoneley wave velocity and support vector machine neural networks: a case study of the Cheshmeh Khush Field, South Iran
Accurate permeability estimation has always been a concern in determining flow units, assigning appropriate capillary pressure andrelative permeability curves to reservoir rock types, geological modeling, and dynamic simulation.Acoustic method can be used as analternative and effective tool for permeability determination. In this study, a four-step approach is proposed for permeability estimati...
متن کاملDetermination of Principal Permeability Directions in Reservoir Rocks from Micro-CT Data
The routine measurement of direction-dependent reservoir rock properties like permeability often takes place along the axial direction of core samples. As permeability is a tensor property of porous materials, it should be fully described by a tensor matrix or by three main permeabilities in principal directions. Due to compaction, cementation, and other lithification processes, which take plac...
متن کاملDetermination of the Complex Permittivity Values of Planar Dielectric Substrates Bymeans of Amultifrequency Pso-based Technique
In this paper, an innovative technique for the determination of the dielectric properties of planar substrates is presented. Starting from a set of impedance measurements performed on a section of a microstrip transmission line built on the planar dielectric substrate under test, the proposed technique formulates the reconstruction problem in terms of an optimization one successively solved by ...
متن کاملSeven State PTP for Vector Network Analyzer
A new, seven-state switched perturbation twoport (PTP) for vector reflection measurement based on scalar measurement only was designed and realized in microstrip structure using PIN diodes. The structure was experimentally tested by means of vector measurements of different impedances in frequency band with relative bandwidth of 2.5 octaves. Good agreement with data obtained using a precise vec...
متن کاملMeasuring Capacitor Parameters Using Vector Network Analyzers
Abstract—Vector network analyzer (VNA) is versatile measuring equipment which is primarily used for two-port device S parameters measurements. This paper addresses measurement of capacitor parameters using VNA in broad frequency range. The main attention is focused on the measurement accuracy of capacitors parameters using VNA and proper de-embedding of an experimental setup parasitics to get a...
متن کامل