Electromagnetic Rotary Tables for Mill and Drill Machining
نویسنده
چکیده
MARIO STAMANN Otto von Guericke University Chair of Electrical Drive Systems Universitätsplatz 2 39106 Magdeburg GERMANY [email protected] THOMAS SCHALLSCHMIDT Otto von Guericke University Chair of Electrical Drive Systems Universitätsplatz 2 39106 Magdeburg GERMANY [email protected] ROBERTO LEIDHOLD Otto von Guericke University Chair of Electrical Drive Systems Universitätsplatz 2 39106 Magdeburg GERMANY [email protected]
منابع مشابه
Development of Design and Manufacturing Support Tool for Optimization of Ultrasonic Machining (USM) and Rotary USM
Ultrasonic machining (USM) is a mechanical material removal process used to erode holes and cavities in hard or brittle work pieces by using shaped tools, high-frequency and an abrasive slurry. This paper addresses the concept and development of an expert system (ES) for hard and brittle material, such as glass, quartz, diamond, carbides, semi conducting materials, ceramic and graphite which ca...
متن کاملDevelopment of Design and Manufacturing Support Tool for Optimization of Ultrasonic Machining (USM) and Rotary USM
Ultrasonic machining (USM) is a mechanical material removal process used to erode holes and cavities in hard or brittle work pieces by using shaped tools, high-frequency and an abrasive slurry. This paper addresses the concept and development of an expert system (ES) for hard and brittle material, such as glass, quartz, diamond, carbides, semi conducting materials, ceramic and graphite which ca...
متن کاملSurface roughness in rotary ultrasonic machining: hypotheses and their testing via experiments and simulations
Rotary ultrasonic machining (RUM) is a nontraditional drilling process. It has been used to drill not only brittle but also ductile materials. It was observed that the surface roughness of the drilled hole near the entrance side was better than that near the exit side. However, explanations about this observation could not be found in the literature. This paper aims to provide explanations abou...
متن کاملMechanical Surface Treatments of Ti-6Al-4V Miniplate Implant Manufactured by Electrical Discharge Machining (TECHNICAL NOTE)
Present work aims at multi-mechanical surface treatment of Ti-6Al-4V based-miniplate implant manufactured by electrical discharge machining (EDM) for biomedical use. Mechanical surface treatment consists of consequent use of ultrasonic cleaning, rotary tumbler polishing, and brushing. Surface layers are analyzed employing scanning electron microscopy and energy dispersive X-ray spectroscopy. Al...
متن کاملDesign, Manufacturing and Surface quality Analysis of Machining by Self-Rotary Milling Tool
One of the disadvantages of conventional milling tools is to produce a large amount of heat in cutting zone and so making the tool warmer. As a result, the tool would be worn and its life time would be reduced. Therefore, in long time machining, it is essential to change inserts and tools, continiously. A milling tool with self rotary cutting inserts was designed and manufactured that enables i...
متن کامل