Effect of Ozonation on the Activated Carbon Surface Chemical Properties and on 2-mercaptobenzothiazole Adsorption
نویسندگان
چکیده
−− Benzothiazoles are organic compounds that may produce negative environmental impact when released into watercourses. In particular, 2mercaptobenzothiazole (MBT) are known to be toxic and hard to biodegrade. Activated carbon adsorption and ozonation have been identified as suitable treatment for those contaminants. However, there is some controversy about the effect of carbon surface chemical composition on the MBT adsorption. This paper focuses on this issue and presents experimental adsorption isotherms for MBT on Filtrasorb-400 activated carbon treated with different ozone doses. The activated carbon surface chemical properties were assessed by acid/basic neutralization, temperature programmed desorption (TPD), X-ray photoelectron spectroscopy (XPS), and the point of zero charge (pHPZC). Results show that ozone treatment modified the oxygenated groups on the activated carbon surface, increasing the concentration of acid groups, and reducing the pHPZC. Finally, ozone treatment led to a significant reduction of the carbon’s MBT adsorption capacity, due to the increase in polar hydrophilic groups. Keywords−− 2-Mercaptobenzothiazole, Ozone, Activated Carbon, Surface Properties, Adsorption.
منابع مشابه
Modification of activated carbon by cold plasma and its effect on the adsorption of toluene
Abstract Background and aims: Clean air is one of the basic needs for human health and well-being. However, along with economic growth and development, transportation, urbanization and energy consumption have also risen and provide many concerns such as air pollution, which require urgent and wide attention. Air pollution in the worldwide is considered as a risk factor for human health and one...
متن کاملProduction of Activated Carbon from Cellulose Wastes
Cellulose wastes of a wood and paper factory were used to produce activated carbon. Several chemical agents under various conditions were used for production of activated carbon and hence their adsorption properties have been evaluated. In addition the effect of process parameters such as raw material, chemical agent concentration, impregnation ratio, carbonization temperature, carbonization ti...
متن کاملAdsorption of Phenolic Compounds onto the Activated Carbon Synthesized from Pulp and Paper Mill Sludge: Equilibrium Isotherm, Kinetics, Thermodynamics and Mechanism Studies
A new activated carbon was produced from pulp and paper mill sludge as a low cost precursor via chemical activation by zinc chloride. The activated carbon was successfully used for the adsorption of phenol and two of its derivatives, i.e. 2-chlorophenol and 4-nitrophenol from aqueous solutions. The characterization of the prepared activated carbon demonstrated high textural properties for the s...
متن کاملRemoval of the 2-Mercaptobenotiazole from Model Wastewater by Ozonation
The feasibility of ozonation process for 2-mercaptobenzothiazole (2-MBT) removal follows from results of ozonation of the model wastewater. Total removal of 2-MBT was observed after 20 minutes of ozonation. Very good reproducibility of repeated ozonation trials including sampling and analysis was observed. However, the majority of dissolved organic carbon (DOC) and chemical oxygen demand (COD) ...
متن کاملDye Adsorption on the Blends of Saffron Petals Powder with Activated Carbon: Response Surface Methodology
One of the famous dyes is methylene blue (MB) which is a symbol of hazardous dyes. In this research, methylene blue was adsorbed using the blends of saffron petals with activated carbon. Five independent variables involving pH (2-13), contact time (5-270 min), saffron petals powder dosage (0.1-10 g/l), initial concentration of methylene blue solution (20-300 ppm) and activated carbon dosage (0....
متن کامل