A 1-v 2.4-ghz Double-quadrature Receiver Front-end for Low-voltage Applications
ثبت نشده
چکیده
Recently, battery-operated wireless communication systems with low power consumption and high sustainability on operating time for batteries have wide applications. In these systems, low-power CMOS RF ICs are the key components for achieving system performance goals. One effective means of reducing power dissipation is to decrease supply voltage. Moreover, as CMOS technology moves below 100 nm, supply voltage scaling is also required.
منابع مشابه
A Direct Down-conversion Receiver for Low-power Wireless Sensor Networks
A direct downconversion receiver implemented in 0.13 μm 1P8M process is presented. The circuit is formed by a single-end LNA, an active balun for conversion into balanced mode, a quadrature double-balanced passive switch mixer and a quadrature voltage-controlled oscillator. The receiver operates in the 2.4 GHz ISM band and complies with IEEE 802.15.4 (ZigBee) specifications. The circuit exhibit...
متن کاملMixer Topology Selection for a Multi-Standard High Image-Reject Front-End
In this paper, a mixer topology selection for a multi-standard high image-reject front-end is presented. The receiver is intended to work for Digital Enhanced Cordless Telephone (DECT) systems (at 1.9 GHz and 2.4 GHz) and for Bluetooth (at 2.4 GHz). It will be implemented in 0 18 μm CMOS technology. A double-quadrature low-IF architecture is employed because it can provide a high image rejectio...
متن کاملA 2.4 GHz 3.6mW 0.35mm2 Quadrature Front-End RX for ZigBee and WPAN Applications
a cheaper design. Since an LC-oscillator topology is mandatory to achieve a minimal current draw, the reduction of the number of coils has to be done in the LNA, the mixer and the quadrature generator. In this work, starting from the LNA-Mixer and VCO (LMV) cell topology [2], a single-coil low-power receiver shares the bias current among all the RF blocks of the analog front-end. The receiver p...
متن کاملA transformer-loaded receiver front end for 2.4 GHz WLAN in 0.13 m CMOS technology
A 2.4 GHz radio frequency receiver front end with an on-chip transformer compliant with IEEE 802.11b/g standards is presented. Based on zero-IF receiver architecture, the front end comprises a variable gain common-source low noise amplifier with an on-chip transformer as its load and a high linear quadrature folded Gilbert mixer. As the load of the LNA, the on-chip transformer is optimized for ...
متن کاملA 1.2-V RF Front-End With On-Chip VCO for PCS 1900 Direct Conversion Receiver in 0.13- m CMOS
In this paper, a 1.2-V RF front-end realized for the personal communications services (PCS) direct conversion receiver is presented. The RF front-end comprises a low-noise amplifier (LNA), quadrature mixers, and active RC low-pass filters with gain control. Quadrature local oscillator (LO) signals are generated on chip by a double-frequency voltage-controlled oscillator (VCO) and frequency divi...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2005