3D-Printing of Redox Flow Batteries for Energy Storage: A Rapid Prototype Laboratory Cell

Although interest in redox flow batteries (RFBs) for energy storage has grown over the last few years, implementation of RFB technology has been slow and challenging. Recent developments in 3D-printing of materials enable a transforming technology for fast, reproducible and documented cell manufacture. This technology can give an improved engineering approach to cell design and fabrication, needed to fulfil requirements for lower cost, longer lifetime hardware capable of efficient reliable performance. It can also be used to implement a flexible design methodology to suit various scales of operation, usually important during RFB development. In the case of electrolyte flow features, these needs are especially well met by fast prototyping strategies. This paper demonstrates the importance of 3D-printing for the realization of a hybrid zinc-cerium RFB laboratory cell. The design and fabrication process is described and the benefits offered by 3D-printing are considered. Finally, further opportunities offered by this approach to RFB manufacture and research are highlighted. © The Author(s) 2015. Published by ECS. This is an open access article distributed under the terms of the Creative Commons Attribution Non-Commercial No Derivatives 4.0 License (CC BY-NC-ND, http://creativecommons.org/licenses/by-nc-nd/4.0/), which permits non-commercial reuse, distribution, and reproduction in any medium, provided the original work is not changed in any way and is properly cited. For permission for commercial reuse, please email: [email protected]. [DOI: 10.1149/2.0141504jss] All rights reserved.