Trapping of Tritium by Stainless Steel Exposed to Plasmas in Experimental Campaigns of LHD
نویسندگان
چکیده
1) Hydrogen Isotope Research Center, Univ. of Toyama, Gofuku 3190, Toyama 930-8555, Japan 2) National Institute for Fusion Science, 322-6 Oroshi-cho, Toki 509-5292, Japan 3) Center for Research and Development in Natural Sciences, Univ. of Toyama, Gofuku 3190, Toyama 930-8555, Japan 4) Radiochemistry Research Laboratory, Shizuoka Univ., Shizuoka 422-8529, Japan 5) Laboratory of Plasma Physics and Engineering, Hokkaido Univ., Sapporo 060-8628, Japan
منابع مشابه
Influence of Surface Modifications on the Adsorption and Absorption of Tritium into Stainless-Steel
LLE Review, Volume 147 150 Introduction High concentrations of tritium develop on stainless-steel (SS) surfaces exposed to a tritium atmosphere.1 These high concentrations are attributed to tritium dissolution within the adsorbed water layers present on all metal surfaces.1–4 Tritium dissolved within these layers contributes $20% to the total inventory absorbed by SS.1 Additionally, these water...
متن کاملMachinability Improvement of 17-4PH Stainless Steel by Cryogenic Cooling
17-4PH stainless steel is a martensitic precipitation hardening stainless steel that provides an outstanding combination of high strength, good corrosion resistance, good mechanical properties, good toughness in both base metal and welds, and short time, low-temperature heat treatments that minimize warpage and scaling. This valuable alloy is widely used in the aerospace, nuclear, chemical, pet...
متن کاملStress Corrosion Cracking Detection of Sensitized Stainless Steel 304 in Chloride Media by Using Electrochemical Impedance Spectroscopy (EIS)
Electrochemical impedance spectroscopy (EIS) was used to detect stress corrosion cracking (SCC) in stainless steel 304 alloy exposed to an aqueous environment at 120 °C. Stainless steel 304 alloy as u-bend was tested in the solution that contains 40 weight percent of magnesium chloride. U-bended samples were prepared according to ASTM G30. EIS measurements were always performed simultaneously o...
متن کاملWeldability Comparison of Tritium-charged-and-aged 304 and 316ln Stainless Steels
Measurement of the effects of helium (from tritium decay) on the weldability of Types 304 and ITER Grade 316LN stainless steel demonstrated the inherent complexities in designing and conducting an experimental program using tritium-charged-and-aged materials to simulate the effects of irradiation-induced helium on weld behavior. Differences in microstructure, surface condition and alloy chemist...
متن کاملMachinability Improvement of 17-4PH Stainless Steel by Cryogenic Cooling
17-4PH stainless steel is a martensitic precipitation hardening stainless steel that provides an outstanding combination of high strength, good corrosion resistance, good mechanical properties, good toughness in both base metal and welds, and short time, low-temperature heat treatments that minimize warpage and scaling. This valuable alloy is widely used in the aerospace, nuclear, chemical, pet...
متن کامل