Highly Efficient, Rapid, and Simultaneous Removal of Cationic Dyes from Aqueous Solution Using Monodispersed Mesoporous Silica Nanoparticles as the Adsorbent
نویسندگان
چکیده
In this work, a highly efficient and rapid method for simultaneously removing cationic dyes from aqueous solutions was developed by using monodispersed mesoporous silica nanoparticles (MSNs) as the adsorbents. The MSNs were prepared by a facile one-pot method and characterized by scanning electron microscopy, transmission electron microscopy, Fourier-transform infrared spectroscopy, and Brunauer-Emmett-Teller. Experimental results demonstrated that the as-prepared MSNs possessed a large specific surface area (about 585 m²/g), uniform particle size (about 30 nm), large pore volume (1.175 cm³/g), and narrow pore size distribution (1.68 nm). The materials showed highly efficient and rapid adsorption properties for cationic dyes including rhodamine B, methylene blue, methyl violet, malachite green, and basic fuchsin. Under the optimized conditions, the maximum adsorption capacities for the above mentioned cationic dyes were in the range of 14.70 mg/g to 34.23 mg/g, which could be achieved within 2 to 6 min. The probable adsorption mechanism of MSNs for adsorption of cationic dyes is proposed. It could be considered that the adsorption is mainly controlled by electrostatic interactions and hydrogen bonding between the cationic dyes and MSNs. As a low-cost, biocompatible, and environmentally friendly material, MSNs have a potential application in wastewater treatment for removing some environmental cationic contaminants.
منابع مشابه
Magnetic Solid Phase Extraction and Removal of Five Cationic Dyes from Aqueous Solution Using Magnetite Nanoparticle Loaded Platanusorientalis Waste Leaves
This paper reports on synthesis of a magnetic adsorbent for wastewater treatment purposes. In this regard, platanus orientalis waste leaves were chosen as a cheap material for preparing the magnetic adsorbent by loading magnetite nanoparticles on it. The synthesized adsorbent was characterized using scanning electron microscope and X-ray diffractometer. Then, it was used for magnetic solid phas...
متن کاملNovel modified magnetic mesopouros silica for rapid and efficient removal of methylene blue dye from aqueous media
This reaserch aims at functionalizing magnetic mesoporous silica with methacrylic acid-3-aminopropyltriethoxysilane (Fe3O4@MCM-41@MAA-APTES) applied for removal of methylene blue from aqueous solution. Several variables (such as pH, dye concentration, adsorbent amount and contact time) have been investigated. Under optimum conditions, maximum capacity of 87.71 mg g-1 of MB was obtained for the ...
متن کاملRemoval of Cationic Dyes from Aqueous Solution using Organomodified Nanoclay
In this work, organomodified nanoclay has been used as the adsorbent for the removal ofbasic blue 41, cationic dye from an aqueous solution. The performance of the organomodified nanoclay was tested in a batch system under varying pH (2–12), adsorbent dosage (0.1–2 g L-1), initial dye concentration (10–60 mgL-1), and contact time (5- 100 min). The best conditions were achieved at pH of 7,...
متن کاملRemoval of Reactive Red195 Synthetic Textile Dye using Polypyrrole-coated Magnetic Nanoparticles as an Efficient Adsorbent
Magnetic Fe3 O4 nanoparticles modified by polypyrrole (PPy@Fe3 O4 MNPs) was synthesized by chemical co-precipitation method and used as an adsorbent for removal of cationic dyes, Reactive Red195, from aqueous solutions. The resulting products are characterized by scanning electron microscope (SEM) and FT-IR. The effects of solution pH value, adsorbent amount, adsorption time and capacity of the...
متن کاملLaCo0.5Fe0.5O3 Nanoparticles as a Highly Efficient Adsorbent for Rapid Removal of Trypan Blue Dye From Aqueous Media
Nanoparticles of perovskite-type LaCo0.5Fe0.5O3 (LCFO) were fabricated by sol–gel method.Thermal decomposition process of the complex precursor was examined by means of differentialthermal analysis–thermal gravimetric analysis (DTA/TGA). X-ray diffraction (XRD) resultsshowed that single perovskite phase has been completely formed after calcination at 750 °C. Inaddition, the surface morphology a...
متن کامل