Drying of Municipal Sewage Sludge: from a Laboratory Scale Batch Indirect Dryer to the Paddle Dryer
نویسندگان
چکیده
Among available technologies, disk and paddle dryers are often encountered in France to process municipal sewage sludge but their thermal design is still a question of know how rather than scientific knowledge. From experiments performed on an industrial Naratherm paddle dryer and the literature, a simple model has been developed. The dryer is divided into two parts depending on the sludge consistency. A constant evaporating flow rate is assumed in the pasty zone whereas its linear decrease with the moisture content is taken into account in the granular zone. To compute this model, some of the sludge properties have to be characterized with a set of laboratory scale experimental techniques. The agreement with the experimental data is good.
منابع مشابه
Method for Thermal Design of Paddle Dryers: Application to Municipal Sewage Sludge
An experimental methodology was developed to improve the energy design of paddle dryers for sewage sludges. A laboratory batch dryer with a vertical agitator has been especially designed and instrumented to determine the heat flux densities. To determine the drying kinetic and the evaporating flow rates, the specific heat and the total heat of desorption of the sludge were measured using calori...
متن کاملA new methodology for measurement of sludge residence time distribution in a paddle dryer using X-ray fluorescence analysis.
Drying is a necessary step before sewage sludge energetic valorization. Paddle dryers allow working with such a complex material. However, little is known about sludge flow in this kind of processes. This study intends to set up an original methodology for sludge residence time distribution (RTD) measurement in a continuous paddle dryer, based on the detection of mineral tracers by X-ray fluore...
متن کاملDrying of calcium carbonate in a batch spouted bed dryer: optimization and kinetics modeling
In the present work, the drying of calcium carbonate in a batch spouted bed dryer with inert particles has been investigated experimentally. The effect of several operating parameters including air temperature (90, 100, and 110 ˚C), air velocity (Ums, 1.2 Ums, and 1.5 Ums), and dry solid mass (5, 10, 20 g) has been studied. The Taguchi method has been applied to determine the optimal parameters...
متن کاملImproving the heat transfer properties of waste activated sludge by advanced oxidation processes
The disposal of Waste Activated Sludge is a major problem. The paper presents several disposal routes. The ultimate steps in these routes are indirect drying and subsequent incineration. Although the design of the indirect dryers is straightforward from a required heat input, operating temperature difference between sludge bed and heating medium and the heat transfer coefficient, this coefficie...
متن کاملModeling of the Fouling Probability of an Activated Sludge Dryer
Better understanding (and so better control) of the stickiness phenomenon of drying sludge is critical for proper operation of a variety of industrial dryers, as is the case for the combined centrifuge-dryer system used on the Monsanto Europe site in Antwerp, Belgium. In this paper a binary logistic regression analysis is performed on a 4-years data base, which resulted in an empirical model fo...
متن کامل