Signal-to-Interference-plus-Noise Ratio Estimation for Wireless Communication Systems: Methods and Analysis

The Signal-to-Interference-plus-Noise Ratio (SINR) is an important metric of wireless communication link quality. SINR estimates have several important applications. These include optimizing the transmit power level for a target quality of service, assisting with handoff decisions and dynamically adapting the data rate for wireless Internet applications. Accurate SINR estimation provides for both a more efficient system and a higher user-perceived quality of service. In this paper, we develop new SINR estimators and compare their mean squared error (MSE) performance. We show that our new estimators dominate estimators that have previously appeared in the literature with respect to MSE. The sequence of transmitted bits in wireless communication systems consists of both pilot bits (which are known both to the transmitter and receiver) and user bits (which are known only by the transmitter). The SINR estimators we consider alternatively depend exclusively on pilot bits, exclusively on user bits, or simultaneously use both pilot and user bits. In addition, we consider estimators that utilize smoothing and feedback mechanisms. Smoothed estimators are motivated by the fact that the interference component of the SINR changes relatively slowly with time, typically with the addition or departure of a user to the system. Feedback estimators are motivated by the fact that receivers typically decode bits correctly with a very high probability, and therefore user bits can be thought of as quasipilot bits. For each estimator discussed, we derive an exact or approximate formula for its MSE. Satterthwaite approximations, noncentral F distributions (singly and doubly) and distribution theory of quadratic forms are the key statistical tools used in developing the MSE formulas. In the case of approximate MSE formulas, we validate their accuracy using simulation techniques. The approximate MSE formulas, of interest in their own right for comparing the quality of the estimators, are also used for optimally combining estimators. In particular, we derive optimal weights for linearly combining an estimator based on pilot bits with an estimator based on user bits. The optimal weights depend on the MSE of the two estimators being combined, and thus the accurate approximate MSE formulas can conveniently be used. The optimal weights also depend on the unknown SINR, and therefore need to be estimated in order to construct a useable combined estimator. The impact on the MSE of the combined estimator due to estimating the weights is examined. © 2004 Wiley Periodicals, Inc. Naval Research Logistics 51: 720–740, 2004. Correspondence to: D.R. Jeske ([email protected]); A. Sampath ([email protected]) © 2004 Wiley Periodicals, Inc.