To die or not to die.
نویسنده
چکیده
This article presents the author's personal reflections and experiences in providing case management for patients with end-of-life issues. Through case examples and practical guidelines, the reader will gain an insight into dealing with terminal states in the acute care setting. References were drawn from recent literature on the subject, and were the stimulus to this piece.
منابع مشابه
Simulation of a New Process Design to Fabricate a Rectangular Twist Waveguide Using Extrusion and a Twist Die
The aim of the present study is to determine the feasibility of making a rectangular twist waveguide used to rotate electromagnetic waves. For this purpose, the process of fabricating an aluminum rectangular twist waveguide was simulated by making use of finite element method and Deform software. The optimum length and angle of the twist die for manufacturing a twist waveguide with inner cross ...
متن کاملExperimental Investigation of Metal Powder Compaction without Using Lubricant
The main objective of this work was to design a novel device for compaction of metal powders so that the green parts could be ejected with applying a negligible force and without the need for any lubricant in either an admixed form or applied to the die wall. For this purpose a 40 mm diameter one-piece die was envisaged which would elastically contracted 0.076 mm before compaction and after com...
متن کاملO-19: A Comparison of Pelvic Magnetic Resonance Imaging, Trans-Vaginal and Trans-Rectal Sonography with Laparoscopic Findings in The Diagnosis of Deep Infiltrating Endometriosis
Background The performance of TVS, TRS and MRI for the diagnosis of DIE have been separately reported in earlier studies. However, the three methods have not been concurrently compared in terms of their overall performance and classified results as per different anatomical locations of DIE lesions in a large study population. This study was an attempt to compare pelvic magnetic resonance imagin...
متن کاملOptimization of Axisymmetric Extrusion Die Profiles
In this research, optimization process of axisymmetric extrusion dies is proposed. Plastic zone is analyzed using finite element method in the Eulerian system with flow formulation. The die profiles are defined by Bezier curves with six control points. Two effective functions are considered in this research; standard deviation of the strain rate and the rate of energy consumption during extrusi...
متن کاملOptimization of die geometry for Tube Channel Pressing
Since tubes have numerous industrial applications, different attempts are focused on the Severe Plastic Deformation (SPD) processes of tubes. As an illustration, Tube Channel Pressing (TCP) is an attractive process for this purpose since it can be used for processing of different sizes of tubes. However, more attempts are needed to improve the outcomes of TCP. For example, imposing of greater s...
متن کاملOptimum Die Design in Drawing of Square Section Rod from Round Bar
Drawing of square section rod from round bar can be done with two die shapes. In the first die shape, deformation starts from corners of the square and in second die shape, deformation starts from sides of square. This article has compared the drawing force for both die shapes and as a result optimum die shape was determined. Due to complexity of metal flow inside the die, analyzing of actual p...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید
ثبت ناماگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید
ورودعنوان ژورنال:
- The Hastings Center report
دوره 27 6 شماره
صفحات -
تاریخ انتشار 1984