Evaluation of the light energy transmission and bottom/top rate in silorane and methacrylate-based composites with different photoactivation protocols.

AIM This study investigated the influence of different composite resin organic matrix (methacrylate - Filtek Z350 XT and silorane - Filtek P90) on light energy transmission through the composite and bottom/top rate. MATERIALS AND METHODS A light-emitting diode (New Blue Phase), light-curing unit was used with different photoactivation protocols (high-continuous mode - HCM, 1400 mW/cm2 for 20 seconds; low-continuous mode - LCM , 700 mW/cm2 for 40 seconds; and soft-start mode - SSM, 140 mW/cm2 for 5s followed by 39 seconds for 700 mW/cm2). Twenty specimens were prepared for each composite. The light energy transmission through the composite was calculated (n=10). The bottom/top rate of the same specimen was calculated (n=10). The data were compared by Tukey's test in different tests (light energy transmission through the composite and bottom/top rate). RESULTS The light energy transmission through the Filtek Z350 XT composite (HCM - 576 mW/cm2, LCM - 238 mW/cm2, SSM - 232 mW/cm2) did not show statistical difference when compared with Filtek P90 composite (HCM - 572 mW/cm2, LCM - 233 mW/cm2, SSM - 230 mW/cm2). The bottom/top rate of the Filtek Z350 XT composite (HCM - 88.98%, LCM - 90.94%, SSM - 89.92%) was statistically higher than that of the Filtek P90 composite (HCM-77.29%, LCM-77.51%, SSM- 77.79%). CONCLUSION Light energy transmission through the composite was not influenced by the use of different dental composite restoratives. However, the bottom/top rate of the composites was influenced by the use of different dental composite restoratives. CLINICAL SIGNIFICANCE Insufficiently polymerized composite resin may present a large number of problems. For this reason, dental composite resins should have the similar deep surface polymerization as the top surface in dental restorations.