A pedal dynamometer for off-road bicycling.
نویسندگان
چکیده
This paper describes the design and accuracy evaluation of a dynamometric pedal, which measures the two pedal force components in the plane of the bicycle. To realize a design that could be used during actual off-road cycling, a popular clipless pedal available commercially was modified so that both the form and the function of the original design were maintained. To measure the load components of interest, the pedal spindle was replaced with a spindle fixed to the pedal body and instrumented with eight strain gages connected into two Wheatstone bridge circuits. The new spindle is supported by bearings in the crank arm. Static calibration and a subsequent accuracy check revealed root mean square errors of less than 1 percent full scale (FS) when only the force components of interest were applied. Application of unmeasured load components created an error less than 2 percent FS. The natural frequency with half the weight of a 75 kgf person standing on the pedal was greater than 135 Hz. These performance capabilities make the dynamometer suitable for measuring either pedaling loads due to the rider's muscular action or inertial loads due to surface-induced acceleration. To demonstrate this suitability, sample pedal load data are presented both for steady-state ergometer cycling and coasting over a rough surface while standing.
منابع مشابه
A hub dynamometer for measurement of wheel forces in off-road bicycling.
A dynamometric hubset that measures the two ground contact force components acting on a bicycle wheel in the plane of the bicycle during off-road riding while either coasting or braking was designed, constructed, and evaluated. To maintain compatibility with standard mountain bike construction, the hubs use commercially available shells with modified, strain gage-equipped axles. The axle strain...
متن کاملCorrelating Dynamometer Testing to In-Use Fleet Results of Plug-In Hybrid Electric Vehicles
The Untied States Department of Energy is engaged in the research, development and deployment of PHEV technology through the “Advanced Vehicle Testing Activity.” In this program, data has been collected from a Prius PHEV converted by Hymotion using industry standard dynamometer testing procedures and from in-use operation of fleets. Differences in fuel-only consumption rates observed in the on-...
متن کاملThe impact of transportation infrastructure on bicycling injuries and crashes: a review of the literature
BACKGROUND Bicycling has the potential to improve fitness, diminish obesity, and reduce noise, air pollution, and greenhouse gases associated with travel. However, bicyclists incur a higher risk of injuries requiring hospitalization than motor vehicle occupants. Therefore, understanding ways of making bicycling safer and increasing rates of bicycling are important to improving population health...
متن کاملBrainCycles: Experimental Setup for the Combined Measurement of Cortical and Subcortical Activity in Parkinson's Disease Patients during Cycling
Recently, it has been demonstrated that bicycling ability remains surprisingly preserved in Parkinson's disease (PD) patients who suffer from freezing of gait. Cycling has been also proposed as a therapeutic means of treating PD symptoms, with some preliminary success. The neural mechanisms behind these phenomena are however not yet understood. One of the reasons is that the investigations of n...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید
ثبت ناماگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید
ورودعنوان ژورنال:
- Journal of biomechanical engineering
دوره 120 1 شماره
صفحات -
تاریخ انتشار 1998