Proton Diffusion in Nickel Hydroxide Films

نویسنده

  • John W. Weidner
چکیده

Electrochemical impedance spectroscopy (EIS) was used to measure the solid-state diffusion coefficient of protons in nickel hydroxide films at room temperature as a function of state of charge (SOC). A model for the complex faradaic impedance of the nickel hydroxide active material is presented and used to extract the diffusion coefficient of protons from the EIS data. Impedance data over a range of frequencies can be used to extract a constant diffusion coefficient without the knowledge of the initial mobile proton concentration or the form of the charge-transfer kinetic expression. The proton diffusion coefficient is a strong function of SOC and decreases approximately three orders of magnitude from 3.4 • 10 -a to 6.4 • 10 -1~ cm 2 s -1 as the electrode discharges from the completely charged to the completely discharged state. The measurements were performed on well-conditioned nickel hydroxide films and therefore it is likely that the diffusion coefficients measured correspond to the p-phase of the active material. The diffusion coefficient of protons was measured for three different film thicknesses, 1.5, 1.2, and 1.0 ~m. The diffusion coefficient is independent of the thickness of the film as predicted by theory. The three orders of magnitude decrease in the diffusion coefficient of protons can be explained on the assumption that the protons move predominantly through the oxidized phase [NiOOH] which is interdispersed along with the reduced phase [Ni(OH)2] in the active materia].

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

An Electrochemical Route for Making Porous Nickel Oxide Electrochemical Capacitors

Porous nickel oxide films were prepared by electrochemically precipitating nickel hydroxide and heating the hydroxide in air at 300°C. The resulting nickel oxide films behave as an electrochemical capacitor with a specific capacitance of 59 Flg electrode material. These nickel oxide films maintain high utilization at high rates of discharge (i.e., high power density) and have excellent cycle li...

متن کامل

Effect of Proton Diffusion, Electron Conductivity, and Charge-Transfer Resistance on Nickel Hydroxide Discharge Curves

Constant-current discharge curves for the nickel hydroxide electrode are simulated assuming resistances due to diffusion of protons and conduction of electrons through the nickel hydroxide film, and charge-transfer resistance at the film/electrolyte interface contribute to the polarization losses of the electrode. Good qualitative agreement is observed between the model predictions and experime...

متن کامل

Capacitance studies of cobalt oxide films formed via electrochemical precipitation

Cobalt oxide films were prepared by electrochemically precipitating the hydroxide and heating it in air to form Co3O4. The resulting oxide films behave as a capacitor. The materials were studied emphasizing their use as either positive or negative electrodes in devices. The capacitance of the material was estimated at different heating temperatures and insight was gained into the charge storage...

متن کامل

Encapsulation of sulfur with thin-layered nickel-based hydroxides for long-cyclic lithium–sulfur cells

Elemental sulfur cathodes for lithium/sulfur cells are still in the stage of intensive research due to their unsatisfactory capacity retention and cyclability. The undesired capacity degradation upon cycling originates from gradual diffusion of lithium polysulfides out of the cathode region. To prevent losses of certain intermediate soluble species and extend lifespan of cells, the effective en...

متن کامل

Studies on the Capacitance of Nickel Oxide Films: Effect of Heating Temperature and Electrolyte Concentration

Nickel oxide films were prepared by electrochemically precipitating the hydroxide and heating it in air to form the oxide. The resulting oxide films behave as a capacitor. The capacitance of the oxide depends on the heating temperature, showing a maximum at 3008C. The mechanism of charge storage was studied by measuring the capacitance and surface area as a function of heating temperature, and ...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2005