A Three-phase to Three-phase Matrix Converter Prototype
نویسندگان
چکیده
This paper presents some implementation details of a threephase to three-phase matrix converter prototype. The bidirectional semiconductor switches were built using discrete IGBTs and fast diodes. Design aspects such as protection against overvoltage and short-circuit, commutation process Artigo submetido em 23/04/2010 (Id.: 1132) Revisado em 18/09/2010, 15/07/2011, 30/08/2011 Aceito sob recomendação do Editor Associado Prof. Takashi Yoneyama of bidirectional switches, and input filter are addressed in this paper.
منابع مشابه
Three-Phase to Single-Phase Matrix Converters: New Topology Based on New Control Method
In this paper, a new topology is proposed for three-phase to single-phase matrix converters, where more voltage levels are produced in the output in comparison with the conventional topologies. In addition, a new control method based on minimum error between the generated and the desired output voltages is proposed for three-phase to single-phase matrix converters. In the proposed control metho...
متن کاملMulti-Stage DC-AC Converter Based on new DC-DC converter for energy conversion
This paper proposes a multi-stage power generation system suitable for renewable energy sources, which is composed of a DC-DC power converter and a three-phase inverter. The DC-DC power converter is a boost converter to convert the output voltage of the DC source into two voltage sources. The DC-DC converter has two switches operates like a continuous conduction mode. The input current of DC-DC...
متن کاملNeural Network Implementation of a Three Phase Regulated PWM AC to Dc Convener with Input Unbalance Correction
Under unbalanced supply condition low order harmonics will appear at the input and output terminals of the PWM AC to DC converter. Based on the positive and negative sequence components, an unbalanced transfer matrix in terms of the input phase voltages is derived. An on-line method using a neural network (NN) is used to implement this transfer matrix. It is shown that by using an additional lo...
متن کاملDesign and Simulation of a New DC Power Supply Based on Dual Bridge Matrix Converter
A conventional high power DC power supply systems consist of a three-phase diode rectifier followed by a high frequency converter to supply loads at regulated DC voltage. These rectifiers draw significant harmonic currents from the utility, resulting in poor input power factor. In this paper, a DC power supply based on dual-bridge matrix converter (DBMC) with reduced number of switches is p...
متن کاملA Novel Transformer-Based Single-to-Three Phase Conversion Technique Using Rotating Magnetic Field Theory
This paper presents a new single to three phase converter using rotating magnetic field transformer. Conventional transformers have been used in many converters aiming at supplementary improvements and they usually have no critical effect on the conversion technique. In this paper, the conversion technique is based on a special rotating magnetic field transformer in which there are two windings...
متن کاملFlexible Power Electronic Transformer for Power Flow Control Applications
This paper proposes a Flexible Power Electronic Transformer (FPET) for the application in the micro-grids. The low frequency transformer is usually used at the Point of Common Coupling (PCC) to connect the low voltage grid and utility network to each other. The conventional 50Hz transformer results in enhanced low voltage-grid power management system during grid-connected operation. In this pap...
متن کامل