Self-oscillating Electronic Ballast Design for Bipolar Transistor
ثبت نشده
چکیده
TRANSISTOR
منابع مشابه
Automatic Luminous Control for Self-Oscillating Electronic Ballast
This paper presents a simple alternative of automatic luminous control for electronic ballasts operating in selfsustained oscillating mode feeding fluorescent lamps to energy saving. The luminous flux level control is based on a signal from a lighting dependent resistor, which measures the luminous flux level. The dimming feature is obtained using switching frequency variation. Thus, the circui...
متن کاملMulti-Lamp High-Power-Factor Electronic Ballast Using a Fixed-Frequency Self-Oscillating Driver
This paper presents a fixed-frequency self-oscillating high-power-factor electronic ballast supplying four independent lamps. The fixed-frequency self-oscillating driver is achieved adding a LC series filter supplying a small resistor. The primary winding of the self-oscillating transformer is the series inductor of the filter. So, if one or more lamps are damaged, the switching frequency will ...
متن کاملSelf-oscillating Electronic Ballast with Lighting Intensity Control
This paper presents electronic ballast with dimming capability supplying a 32 W fluorescent lamp. The electronic ballast is a self-oscillating driving circuit with an additional circuit responsible for dimming the fluorescent lamp based on a signal from a lighting dependent resistor. This luminous sensor measures the luminous flux level and set the lamp power by the voltage gain variation of th...
متن کاملStudy of Energy Efficient Electronic Ballast
The demand of efficient lighting is increasing day by day. The efficient lighting includes maximum efficacy of light as well as maximum utilization of energy by improving the power factor with less complexity. The discharge lamps with high frequency electronic ballasts are used for maximum efficient lighting. The power factor of the ballast which is used in fluorescent lamp circuit should be in...
متن کاملA Self-Oscillating Drive for Single-Stage Charge-Pump Power-Factor-Correction Electronic Ballast with Frequency Modulation
=AbstractSingle-stage current-source charge-pump powerfactor-correction (SS CS-CPPFC) electronic ballast employs charge-pump concept to obtain high power factor with low cost. However, the circuit has a poor lamp current crest factor and large lamp output power variation, which deteriorates the lamp life. Feed-forward and/or feedback circuit are usually used to deal with these problems at the p...
متن کامل