A reconstruction method for helical computed tomography
نویسندگان
چکیده
This paper presents a method for volumetric reconstruction from Helical Computerized Tomography (H-CT) data which are collected with a fan beam source. An interpretation of the HCT data in terms of the Axial Computerized Tomography (ACT) data is provided. This analysis indicates that the H-CT data for positive and negative detector angles can be combined to form periodically nonuniform hexagonal samples of the A-CT data. A Fourier-based method to reconstruct the A-CT data from this form of data coverage is presented. The target function is then reconstructed using the conventional fan beam computed tomography algorithms for A-CT.
منابع مشابه
3D Image Reconstruction from Truncated Helical Cone Beam Projection Data - A Linear Prediction Approach
With the introduction of 2D flat-panel X-ray detectors, 3D image reconstruction using helical cone-beam tomography is fast replacing the conventional 2D reconstruction techniques. In 3D image reconstruction, the source orbit or scanning geometry should satisfy the data sufficiency or completeness condition for exact reconstruction. The helical scan geometry satisfies this condition and hence ca...
متن کاملFast Variance Prediction for Iterative Reconstruction of 3D Helical CT Images
Fast variance prediction for iteratively-reconstructed helical CT images is useful for analysis of resulting images and potentially for dynamic dose adjustment during a scan. Previous methods require impractical computation times to approximate the image variance; other methods are able to approximate variance quickly but only for specific CT geometries, excluding 3D helical CT. In this paper w...
متن کاملFast System Matrix Calculation in CT Iterative Reconstruction
Introduction: Iterative reconstruction techniques provide better image quality and have the potential for reconstructions with lower imaging dose than classical methods in computed tomography (CT). However, the computational speed is major concern for these iterative techniques. The system matrix calculation during the forward- and back projection is one of the most time- cons...
متن کاملArtifact reduction techniques in Cone Beam Computed Tomography (CBCT) imaging modality
Introduction: Cone beam computed tomography (CBCT) was introduced and became more common based on its low cost, fast image procedure rate and low radiation dose compared to CT. This imaging modality improved diagnostic and treatment-planning procedures by providing three-dimensional information with greatly reduced level of radiation dose compared to 2D dental imaging modalitie...
متن کاملComparing IDREAM as an Iterative Reconstruction Algorithm against In Filtered Back Projection in Computed Tomography
Introduction: Recent studies of Computed Tomography (CT) conducted on patient dose reduction have recommended using an iterative reconstruction algorithm and mA (mili-Ampere) dose modulation. The current study aimed to evaluate Iterative Dose Reduction Algorithm (IDREAM) as an iterative reconstruction algorithm. Material and Methods: Two CT p...
متن کامل