Monolithic SiGe HBT Feedforward Variable Gain Amplifiers for 5 GHz Applications
نویسنده
چکیده
ETRI Journal, Volume 28, Number 3, June 2006 ABSTRACT—Monolithic SiGe heterojunction bipolar transistor (HBT) variable gain amplifiers (VGAs) with a feedforward configuration have been newly developed for 5 GHz applications. Two types of the feedforward VGAs have been made: one using a coupled-emitter resistor and the other using an HBT-based current source. At 5.2 GHz, both of the VGAs achieve a dynamic gain-control range of 23 dB with a controlvoltage range from 0.4 to 2.6 V. The gain-tuning sensitivity is 90 mV/dB. At VCTRL= 2.4 V, the 1 dB compression output power, P1-dB, and dc bias current are 0 dBm and 59 mA in a VGA with an emitter resistor and -1.8 dBm and 71mA in a VGA with a constant current source, respectively.
منابع مشابه
SiGe HBT wideband amplifier for millimeter wave applications
A wideband amplifier up to 50 GHz has been implemented in a 0.25 μm, 200 GHz f t SiGe BiCMOS technology. Die size was 0.7×0.73 mm. The two-stage design achieves more than 11 dB gain over the whole 20 to 50 GHz band. Gain maximum was 14.2 dB at 47.5 GHz. Noise figure was lower than 9 dB up to 34 GHz and a current of 30 mA was drawn from a 4 V supply. To the author’s best knowledge this is the hi...
متن کاملAn 8.4 GHz SiGe/Si HBT-Based MMIC Power Amplifier
A single-stage X-band MMIC power amplifier incorporating a SiGe/Si power HBT and lumped passive components is reported. The power HBT is characterized by an fmax of 67 GHz and a BVCBO of more than 24 V. The matching circuits were designed for maximum output power using on-chip spiral inductors and SiO MIM capacitors. Continuous wave measurements were made at 8.4 GHz, under class A operation. Th...
متن کاملA 2.4-GHz LNA: Design, Simulation, and Comparison in 0.2-μm GaAs p-HEMT Process and 0.35-μm SiGe BiCMOS HBT Process
An LNA design and simulation using ED02AH Technology in 0.2-μm GaAs Pseudomorphic HEMT process and 0.35-μm HBT SiGe BiCMOS process are reported as a case of comparison. This work uses an identical circuit topology for both processes which is a 3-volt two stage cascode single-ended topology with a resistive shunt feedback. This LNA is developed for 2.4 GHz ISM band applications. This letter desc...
متن کاملHigh-Frequency Low-Noise Amplifiers and Low-Jitter Oscillators in SiGe:C BiCMOS Technology
This paper describes the design of noise-critical circuits for radio-frequency and high-speed digital applications in a SiGe:C BiCMOS technology. Starting with a figure of merit for the high-frequency noise behavior of bipolar transistors, challenges in the transistor design are formulated. It is shown that the addition of carbon to the base of a SiGe-HBT results in an excellent high-frequency ...
متن کاملDesign of a 32.7-GHz Bandwidth AGC Amplifier IC with Wide Dynamic Range Implemented in SiGe HBT
A wide-bandwidth automatic gain control (AGC) amplifier IC was developed using a self-aligned selective-epitaxial SiGe heterojunction bipolar transistor (HBT). A transimpedance load circuit was used, and its damping factor was optimized to achieve a wide bandwidth of 32.7 GHz. Capacitor peaking was introduced to the second variable-gain amplifier in order to obtain a wide gain dynamic range of ...
متن کامل