Adsorption of 99mTc-sestamibi onto plastic syringes: evaluation of factors affecting the degree of adsorption and their impact on clinical studies.

نویسندگان

  • Tiffinee N Swanson
  • Duong T Troung
  • Andrew Paulsen
  • Carrie B Hruska
  • Michael K O'Connor
چکیده

UNLABELLED The purpose of this study was to document the extent of adhesion of (99m)Tc-sestamibi to syringes in patient procedures, determine factors that influence the degree of adhesion, and evaluate alternatives to our current practice that would either result in a more reproducible degree of adhesion or, ideally, eliminate adhesion. METHODS The extent of adhesion was documented in 216 patient procedures and evaluated in detail in an additional 73 patient procedures. We evaluated the nature of the adhesion and its possible causes, including the location of adhesion in injection sets, the effect of syringe type, and the effect of prerinsing of syringes with various solutions of nonradiolabeled sestamibi and (99m)Tc-sestamibi. The extent of adhesion was reevaluated in 50 procedures performed using the syringe type that demonstrated the lowest adhesion rate. RESULTS The degree of adhesion of (99m)Tc-sestamibi to the injection set was found to be 20.1% ± 8.0%, with a range (10th-90th percentiles) of 9%-31%. The primary cause of adhesion appeared to be the lubricant used inside the syringe barrel. Evaluation of 6 different syringe types identified a brand with a lower adhesion rate. Reevaluation in patient procedures using this brand showed a 5.2% ± 2.5% degree of adhesion, with a range (10th-90th percentiles) of 2.5%-7.7%. CONCLUSION Selection of the appropriate type of syringe can significantly reduce the magnitude and variability of residual (99m)Tc-sestamibi activity. With more reproducible residual activities, we have been able to achieve an approximately 20% reduction in the dispensed dose of (99m)Tc-sestamibi used in clinical procedures and a more consistent injected dose with less interpatient variation. The frequent changes in syringe design by manufacturers require that a quality control program for monitoring of residual activity be incorporated into clinical practice. This program has allowed us to maintain image quality and achieve more consistent injected patient doses in clinical procedures that use (99m)Tc-sestamibi.

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Adsorption of some technetium-99m radiopharmaceuticals onto disposable plastic syringes.

OBJECTIVE The purpose of this study was to determine the adsorption behavior of some widely used, commercially available 99mTc radiopharmaceuticals onto different types of plastic syringes. METHODS Kits were reconstituted with 99mTc-pertechnetate diluted with 0.9% saline to produce maximum radioactive concentrations, as stated by the manufacturers. Aliquots of the solutions were transferred t...

متن کامل

Adsorption of (99m)Tc-radiopharmaceuticals onto injection vials and syringes.

UNLABELLED Many groups have reported the adsorption or retention of (99m)Tc-radiopharmaceuticals on injection vials and disposable plastic syringes. Such an enormously high loss of radioactivity would result in poor images, radiation exposure, waste, and economic burdens. We therefore decided to investigate the extent of adsorption or retention of several (99m)Tc-radiopharmaceuticals on injecti...

متن کامل

Adsorption of Phenolic Compounds onto the Activated Carbon Synthesized from Pulp and Paper Mill Sludge: Equilibrium Isotherm, Kinetics, Thermodynamics and Mechanism Studies

A new activated carbon was produced from pulp and paper mill sludge as a low cost precursor via chemical activation by zinc chloride. The activated carbon was successfully used for the adsorption of phenol and two of its derivatives, i.e. 2-chlorophenol and 4-nitrophenol from aqueous solutions. The characterization of the prepared activated carbon demonstrated high textural properties for the s...

متن کامل

Adsorption Properties of Folic Acid onto Functionalized Carbon Nanotubes: Isotherms and Thermodynamics Studies

In the present research, we report the results of a systematic study on the adsorption properties of folic acid (FA) over functionalized single-walled carbon nanotubes (SWCNTs) using the various factors, such as adsorbent dose, contact time, temperature, and initial FA concentration. Our results reveal that SWCNT is an excellent adsorbent for folic acid, with an adsorption percentage of up to 7...

متن کامل

Combination of Experimental Design and Desirability Function as a Genuine Method to Achieve Common Optimal Conditions for the Adsorption of Pb(II) and Cu(II) onto the Poplar Tree Leaves: Equilibrium, Kinetic and Thermodynamic Studies

In this study, the ashes of poplar tree leaves are applied as an efficient, accessible and inexpensive biosorbent for the removal of heavy metals Pb2+ and Cu+2 in aqueous solutions. In the adsorption processes, the success of the ions removal highly depends on the level of several experimental factors such as pH, contact time, adsorbent dosage and temperature. Therefore, a genuine statistical e...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

عنوان ژورنال:
  • Journal of nuclear medicine technology

دوره 41 4  شماره 

صفحات  -

تاریخ انتشار 2013