Wave Digital Modeling of the Output Chain of a Vacuum-tube Amplifier
نویسندگان
چکیده
This article introduces a physics-based real-time model of the output chain of a vacuum-tube amplifier. This output chain consists of a single-ended triode power amplifier stage, output transformer, and a loudspeaker. The simulation algorithm uses wave digital filters in digitizing the physical electric, mechanic, and acoustic subsystems. New simulation models for the output transformer and loudspeaker are presented. The resulting real-time model of the output chain allows any of the physical parameters of the system to be adjusted during run-time.
منابع مشابه
Non-linear modeling, analysis, design and simulation of a solid state power amplifier based on GaN technology for Ku band microwave application
A new non-linear method for design and analysis of solid state power amplifiers is presented and applied to an aluminum gallium nitride, gallium nitride (AlGaN-GaN) high electron-mobility transistor (HEMTs) on silicon-carbide (SiC) substrate for Ku band (12.4 13.6 GHz) applications. With combining output power of 8 transistors, maximum output power of 46.3 dBm (42.6 W), PAE of 43% and linear ga...
متن کاملSecond Harmonic Reduction of Traveling Wave Tube Amplifier Using Ferrite Material
Traveling Wave Tubes (TWTs) consist of different elements. The most important element of TWT is the RF circuit. RF circuits in helix TWTs need a dielectric support to hold the helix; this support also has an effect in electromagnetic properties of RF circuits. A novel dielectric support is proposed to reduce the second harmonic of helix TWTs. The dielectric support in this structure consists of...
متن کاملHigh-power GaN HEMTs battle for vacuum-tube territory
The market for millimeter-wave power amplifiers includes applications in military, commercial and consumer sectors. The armed forces use the devices in transmitters for the detection of small targets and target imaging, in radar equipment, communications and smart weapons systems. In the commercial sector the amplifiers are widely used in high-data-rate communication systems such as digital rad...
متن کاملEffective Design of a 3×4 Two Dimensional Distributed Amplifier Based on Gate Line Considerations
In this paper two dimensional wave propagation is used for power combining in drain nodes of a distributed amplifier (DA). The proposed two dimensional DA uses an electrical funnel to add the currents of drain nodes. The proposed structure is modified due to gate lines considerations. Total gain improvement is achieved by engineering the characteristic impedance of gate lines and also make appr...
متن کاملPower Amplifier Linearization Using Six-port Receiver for DVB-S2 Satellite Communications
A digital look-up table adaptive predistortion technique using a six-port receiver for power amplifier linearization is presented. The system is designed in Ka-band for a DVB-S2 satellite link. We use a six-port receiver at the linearizationloop in place of classic heterodyne receivers. The six-port receiver is implemented by the use of passive microwavecircuits and detector diodes. This approa...
متن کامل