Influence of Poisson's ratio on elastographic direct and inverse problems.

نویسنده

  • J Fehrenbach
چکیده

We consider the displacement of an elastic material under an external compression (axial or almost axial stress). We assume that only one component of the displacement is observed, in the direction of compression (axial displacement), or alternatively, that two components are observed in a plane. These hypotheses are in accordance with an imaging modality, namely ultrasonic elastography. In the case of a homogeneous medium we show that any value of Poisson's ratio allows us to predict the observed value of the axial displacement. When two components of the displacement are measured in a plane, the Poisson's ratio of the plane strain model that predicts the observed displacement is not the same as the tri-dimensional material. These facts are illustrated by numerical experiments in the case of an inhomogeneous medium. We also present results on experimental phantom data, where the inverse problem of reconstructing the Young's modulus is solved assuming different values for Poisson's ratio.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Assessing image quality in effective Poisson's ratio elastography and poroelastography: I.

The quality of strain estimates in elastography is typically quantified by several quality factors such as the elastographic signal-to-noise ratio, the elastographic contrast-to-noise ratio and the spatial axial and lateral resolutions. While theoretical and simulation works have led to established upper bounds of these image quality factors in axial strain elastography, the performance limitat...

متن کامل

Calculating tissue shear modulus and pressure by 2D Log-Elastographic methods.

Shear modulus imaging, often called elastography, enables detection and characterization of tissue abnormalities. In this paper the data is two displacement components obtained from successive MR or ultrasound data sets acquired while the tissue is excited mechanically. A 2D plane strain elastic model is assumed to govern the 2D displacement, u. The shear modulus, μ, is unknown and whether or n...

متن کامل

Assessing image quality in effective Poisson's ratio elastography and poroelastography: II.

Poroelastography is a novel elastographic technique for imaging the time variation of the mechanical behaviour of poroelastic materials. Poroelastograms are generated as a series of time-sequenced effective Poisson's ratio (EPR) elastograms, obtained from the imaged material under sustained compression. In the companion report (Righetti et al 2007 Phys. Med. Biol. 52 1303), we investigated imag...

متن کامل

Two-Layer Elastographic 3-D Traction Force Microscopy

Cellular traction force microscopy (TFM) requires knowledge of the mechanical properties of the substratum where the cells adhere to calculate cell-generated forces from measurements of substratum deformation. Polymer-based hydrogels are broadly used for TFM due to their linearly elastic behavior in the range of measured deformations. However, the calculated stresses, particularly their spatial...

متن کامل

AN IMPROVEMENT TO PHYSICAL PROPERTIES OF HEAVY-WEIGHT OIL WELL CEMENTS USING CARBON NANOTUBES

This study experimentally investigates the effect of multi-walled carbon nanotubes (MWNT’s), as a reinforcing material, on the physical properties of heavy-weight oil well cements. A candidate well is selected and the properties of the cement slurry used in a problematic section of the well are tested in the laboratory. Carbon nanotubes (CNT’s) are added as fibers to the cement slurry and the i...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:
  • Physics in medicine and biology

دوره 52 3  شماره 

صفحات  -

تاریخ انتشار 2007