Influence of Thermal Treatment on Structure and Corrosion Properties of High Manganese Triplex Steels
نویسنده
چکیده
S. Lasek, E. Mazancová, VŠB-Technical University of Ostrava, FMMI Czech Republic In this paper corrosion properties of X70MnAl28-9 TRIPLEX steel were tested after hot rolling and subsequent aging at 500 °C for 6, 30 and 60 min. and at 600 °C for the same times. For comparison related steels(X100MnAl28-12, X70Mn22, C20) were also used. The microstructure wascharacterized by light microscopy, SEM, energy disperse Xray microanalysis. The corrosion behaviour of steels wasexamined by light and scanning electron microscopy, electrochemical techniques (potenciodynamic polarization method, linear polarization, using NaCl and H2SO4 water solutions), salt spray test and gravimetric method. Aging has relatively small infl uence on corrosion resistance of X70MnAl28-9 steel. The localized corrosion in relation to structure and phases is discussed and compared in terms of dissolution, pitting and changes inchemical composition.
منابع مشابه
Influence of High Strain Rates on the Mechanical Behavior of High-Manganese Steels
In this work, dynamic mechanical properties of three high-manganese steels with TRIP/TWIP or fully TWIP characteristics are studied. High strain rate experiments in the range of true strain rates between ~500 and 1800 /s are conducted using a dynamic torsional testing setup. All the three steels show a positive strain rate sensitivity in the intermediate range of strain rates (up to 500 /s). Bu...
متن کاملInfluence of Ni Deposition and Subsequent N+ Ion Implantation at Different Implantation Energies on Nano-Structure and Corrosion Behavior of 316 Stainless Steels
Nickel films of 300 nm thickness were deposited by electron beam evaporation at room temperature on 316 stainless steels. Corrosion studies of Ni coated 316 SS have been performed after N+ ion implantation at different energies of 20, 40, 60 and 80 keV. The structure and surface morphology of the films were evaluated using X-ray diffraction (XRD), atomic force microscope (AFM) an...
متن کاملI I 1 The Effect of Trace Imparitieo on the Stress -
A series of 18 Ni (300 grade) maraging steels of overall commercial purity but containing also deliberate impurity additions of sulphur, phosphorus, carbon, chromium and silicon + manganese has been studied. The fracture toughness and stress-corrosion resistance (determined using planestrain fatigue-precracked specimens tested in 3. 5% sodium chloride solution) of these steels have been compare...
متن کاملPrediction of Mechanical Properties of TWIP Steels using Artificial Neural Network Modeling
In recent years, great attention has been paid to the development of high manganese austenitic TWIP steels exhibiting high tensile strength and exceptional total elongation. Due to low stacking fault energy (SFE), cross slip becomes more difficult in these steels and mechanical twinning is then the favored deformation mode besides dislocation gliding. Chemical composition along with processing ...
متن کاملInvestigating the Effect of the Deep Cryogenic Heat Treatment on the Mechanical Properties and Corrosion Behavior of 1.2080 Tool Steel
Deep cryogenic heat treatment is assumed as a supplementary heat treatment performed on steels before the final tempering treatment to enhance the wear resistance and hardness of the steels. In this study, the effects of the deep cryogenic heat treatment on the wear behavior and corrosion resistance of the 1.2080 tool steel were studied using the wear testing machine and polarization and impeda...
متن کامل